NH Restoration

NH Restoration Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from NH Restoration, Automotive Restoration Service, Chetnole Road, Yetminster.

21/05/2026

Full custom stainless exhaust systems are now on the menu 🎺

TIG welded and backpurged to your exact specifications πŸ‘¨β€πŸ­

This Audi 80 was crying out for a replacement of the rusty original system. The owner asked for a nice tone without adding too much volume for everyday cruising. This 2.25" 3-box system has done the trick πŸ‘Œ

Who wants the first NH Restoration Mk2 exhaust then? πŸ€”
β€’
β€’

30/04/2026

Fresh valance in on top of those rebuilt corners πŸ‘¨β€πŸ­

I had to bring the valance join higher than usual to allow for a repair to the boot floor.

Spot welded onto the repaired floor and TIG welded on the joint above to ensure it's nice and straight πŸ“πŸ˜Ž
β€’
β€’

These Mk2 rear pockets can hide rust so well - especially when someone has fired a load of fresh underseal over the top ...
25/04/2026

These Mk2 rear pockets can hide rust so well - especially when someone has fired a load of fresh underseal over the top of it all!

If you're in doubt if yours is needing some attention, just give the towing eye a good shame. If it comes off in your hand, that's a good clue 🫣
β€’
β€’

A couple of new floor bungs fabbed up and welded in on the E30 πŸ•³οΈπŸ•³οΈβ€’β€’
16/04/2026

A couple of new floor bungs fabbed up and welded in on the E30 πŸ•³οΈπŸ•³οΈ
β€’
β€’

New rear towing eye bracket fabbed up, it's all in the details πŸ”β€’β€’
14/04/2026

New rear towing eye bracket fabbed up, it's all in the details πŸ”
β€’
β€’

What's your dream spec Mk2? Big bumper or small bumper?8v or 16v?Modified or OEM?Drop your dream build spec in the comme...
13/04/2026

What's your dream spec Mk2?

Big bumper or small bumper?

8v or 16v?

Modified or OEM?

Drop your dream build spec in the comments πŸ‘‡

*Bonus points if you've already built it πŸ‘€*
β€’
β€’

A true pleasure to see this Oak Green beauty again after restoring the engine bay a couple of years ago ✨Rust repair is ...
08/04/2026

A true pleasure to see this Oak Green beauty again after restoring the engine bay a couple of years ago ✨

Rust repair is on the menu this time - watch this space πŸ‘€
β€’
β€’

The workshop actually looked presentable for the first time in a while for .polo.shed meet at the weekend! It was great ...
07/04/2026

The workshop actually looked presentable for the first time in a while for .polo.shed meet at the weekend!

It was great to chat up with some familiar and new faces, ace variety of cars to boot πŸ‘Œ
β€’
β€’

A spot of modification on this Milltek 4-1 before installation 🎺All TIG welded and back purged πŸ‘¨β€πŸ­β€’β€’
01/04/2026

A spot of modification on this Milltek 4-1 before installation 🎺

All TIG welded and back purged πŸ‘¨β€πŸ­
β€’
β€’

Uprated Mk2 Golf starter motors! βš™οΈFollowing the interest in these motors on my last post, I'm producing a small batch -...
29/03/2026

Uprated Mk2 Golf starter motors! βš™οΈ

Following the interest in these motors on my last post, I'm producing a small batch - these will be Β£189 + p&p

- torque multiplying planetary gear set for faster and stronger starts
- plug and play factory electrical terminals incl. K-jet cold start
- no brass bell housing bushing required, a common failure point

The main reason I found this solution was to solve a problem with my own car 'kicking back' starters on hot starts due to the advanced ignition timing I run. These starters are fast and strong enough to overcome the kick back on my 2.0L 16v running 8Β°BTDC base timing.

It's been a night and day difference on hot starts!

Drop me a message to place an order, this first batch will be very limited while I gauge interest πŸ“©
β€’
β€’

It's been a pleasure to see this stunner of a 16v again for some servicing and mods πŸ”§- k-jet compatible uprated starter ...
24/03/2026

It's been a pleasure to see this stunner of a 16v again for some servicing and mods πŸ”§

- k-jet compatible uprated starter fitted
- gear linkage upgrade
- US dash and door card stripes
- service and inspection
β€’
β€’

Address

Chetnole Road
Yetminster
DT96HQ

Telephone

+447960543155

Website

Alerts

Be the first to know and let us send you an email when NH Restoration posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Share