Valley Rod & Custom

Call Directions Contact the business

Valley Rod & Custom Traditional Hotrods, Streetrods, and Muscle cars. Specializing in metal fabrication and restoration.

10/09/2026

Front wheel tubs and engine cover panels are all fabricated. Now just need to build a double walled trans tunnel and driveline tunnel and blow it all apart to start finish welding it all in. Adam Bentley

10/06/2026

Been super busy in the shop lately and haven’t posted much! But here’s a quick video of the front air intake to the radiator panel for the Econoline project. Adam Bentley

09/12/2026

Everyday I strive to be better than I was the day before. But one thing I have learned is that any panel you set out to make, is and only will be as good as the measurements and layout you do before any cuts, bends or hammer blows are made. Take those two seconds extra, be concise, be accurate, be confident 🤘

09/06/2026

Getting started on the inner sheets of the engine doghouse for the Econoline project. The engine doghouse and trans tunnel will end up being double walled, in hopes for a cool and quiet ride!

Hey friends, looking for a new sheet metal shear. 16g capacity is a minimum, hydraulic or pneumatic preferred might cons...
09/02/2026

Hey friends, looking for a new sheet metal shear. 16g capacity is a minimum, hydraulic or pneumatic preferred might consider a stomp shear for the right price. Thanks! (Picture for reference)

08/22/2026

Getting a start on the rear portion of the Adam Bentley Econoline floor this week. Will be adding some beadwork to these panels before all said and done.

Kenny’s Rod Shop is sending over this AWESOME slammed Econoline belonging to Adam Bentley. We’re going to be building a ...
08/18/2026

Kenny’s Rod Shop is sending over this AWESOME slammed Econoline belonging to Adam Bentley. We’re going to be building a new floor from front to back, custom stainless exhaust, multiple ac units, custom dash, and some cool wrap around seating so all the Fam can jump in and go for a cruise. Stay tuned for some progress!

Was lucky this week and had my Dad come in and lend me a hand get this partition panel started on Sid’s 36.
08/17/2026

Was lucky this week and had my Dad come in and lend me a hand get this partition panel started on Sid’s 36.

08/06/2026

Got the engine bay sheet metal pretty much wrapped up on the Kenny’s Rod Shop Chevy Blazer project. Always a fun day working with these guys.

07/25/2026

Getting a start on the 1/2” round rod around the whole bottom of this awesome 36 Coupe.

Address

Boise, ID
83701–83799

Telephone

+13608524853

Website

Alerts

Be the first to know and let us send you an email when Valley Rod & Custom posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Valley Rod & Custom:

Shortcuts

Share

Category