19/02/2026
New manifold for X30 incoming!
Pre-order now, so you don’t miss out!!
NOTICE: 2026 X30 CNC Inlet Manifold
As many customers may have noticed in the 2026 homologations released earlier in the week a new CNC inlet manifold has been introduced for the X30 engine.
In their constant pursuit of excellence IAME have developed this refined component for improved consistency between engines with its dimensional accuracy while improving the mixture of fuel/air making it easier for drivers to obtain an optimal tune.
As the manifold has now been approved for use pending arrival they have been ordered from IAME via airfreight to expedite their availability to any customers who may want to purchase them.
As the estimated delivery date falls very close to the first round of the AKC the decision has been made to withhold their introduction Australia wide until the 16th March 2026 to avoid the possibility of some competitors being able to obtain them in time for round 1 and some not.
As per the homologation and pictured below the manifold is anodised grey in colour, exclusive to Australia and is a direct replacement for the current cast inlet manifold that may continue to be used indefinitely.
Although no manifolds will be distributed prior to the above release date any competitor found to be using one in competition, however it may have been obtained will be disqualified.
REMO RACING
[email protected]
https://www.karting.net.au/administration/technical/
