Prc fab works

16/06/2026

In and amongst some last minute boat crack repairs,managed to get the back board for the plenum on,welded and radiused. It’s definitely starting to take shape👌💪

15/06/2026

For nice welds,you need good fit ups. Lucky this heads ally and not cast iron,the weight of it as is,is tripping my power board out😂

25/05/2026

Injector bosses,fuel rail then plenum. Getting there 💪

04/05/2026

Remember this manifold from a month or so ago? Well the guys planned to test a few different intakes on the dyno but haven’t quite got there yet. However they raced locally last night and had some awesome results!

24/04/2026

Jzed runner pressing today. Thanks for your patience guys,I’m getting through them💪👍👌

16/04/2026

A few of you legends have inquired about my intakes fitting in lj torana engine bays,there you go. Fits easily with about 20mm to the rail.

30/03/2026

2bbl Holden 6 intake

29/03/2026

2bbl 9 port headed intake all finished up.
It’s been done in such a way so the runners are almost the same length whilst keeping the carb the traditional way👌

24/03/2026

23/03/2026

The most painful job almost done. Cut to length,tapered,burr finished and welded. This intake will cop a divider even through its 9 port. Chasing air speed at a lower rpm and with the correct csa it should keep it going in the top end👌