Race Protocol

08/21/2026

Foxbody Friday!

This supercharged mustang came to us not running quite right and the owner wanted us to check it over. After some diagnosis we discovered not only it had a bad fuel injector but also mismatched sizes!
We hooked it up to our Mainline DynoLog Dynamometers, put in a fresh set of Fuel Injector Clinic 525s, and did a full tune on the Holley Performance terminator and it's back to 100 making healthy power on only 5lbs of boost!

08/13/2026

Always a full house here at the shop!

06/27/2026

Been a busy couple of weeks at the shop! Quite a few older cars lately with all kinds of variety.
This 57 belair stock car is in for race prep for a hill climb next month.

A Superperformance 427 Cobra in for alignment and wheel balancing before heading to Detroit for the Woodward Dream Cruise.
Also in the background is a big tire ranchero drag car we put together a custom set of stainless headers for.

This authentic 356 SC came to us after not running for a few years, going to get the fuel system cleaned out and refresh it back to driving!

This S10 is sporting a 327 under the hood. While it was already pretty cool in its own right, but the owner wanted to make it even cooler and had us install and setup an iconic Holley Tri-power setup!

It was a tight squeeze getting it all in there, but it was such cool setup once it was done.

05/30/2026

Fixing an exhaust system. Replaced broken solid hangers with rubber mounts, new muffler and resonator to quiet it down. Tucked it all up tighter to the chassis and split it in the middle with a v-band for better serviceability.

05/22/2026

Data, information, and electronics are just as important as horsepower and suspension to a race program!

Here we are running an SW4 steering wheel with their Solo2 lap timer all communicating via CAN to a .ecu G4x Extreme and Razor PDM to not only provide all the essential running data to the driver but log everything to the ECU in this 944 racecar.

Thinking about custom electronics or wiring? Let us know and we can build something for your application!

05/15/2026

Converted manual rack with almost 0.50 deg of slop out. A nice new true manual rack going in!

05/15/2026

05/07/2026

3d printed collectors.... Good or bad?

04/16/2026

90° outlet compressor mod on a g25-660

03/29/2026

The Blackwall Smoothy

Diamond Back Tire