GrazianoPDR

04/01/2023

Large crease on this Infiniti door! Turned out very nice.

04/01/2023

Super sharp dent on this Infiniti door! It had about a 1/4 inch chip from the initial impact. Was able to get about 95 percent of the dent out. Although it wasn’t super big in diameter due to the depth and sharpness it was a very time consuming and difficult dent to do!

12/22/2022

Deep dent through the body line on this newer Dodge Ram! Came out nice.

12/18/2022

Some pdr action on this aluminum Audi door. There was a lot of bracing inside the door that was preventing me from pushing them so it was done 100% with glue pull. Turned out nice!

12/16/2022

A quick little dent on a Cadillac quarter panel. This was completed by removing the tail light and going through a factory hole.

12/16/2022

11/05/2022

Customer didn’t want to put a new fender on or go the paint route due to it being an older vehicle. So we did some pulling and metal manipulation to get it back to a general shape. Turned out nice.

11/05/2022

10/15/2022

Due to being primarily a mobile service and the weather being cold again, I will be no longer taking in work until spring.

10/04/2022

Just some smaller dents on a deck lid.

09/15/2022

Definitely in the top ten of the hardest dents I’ve done. Large deep crease on this chevy truck! Super happy on how it turned out, took about 6 hours to do.

09/15/2022

Not all dents are the same, this is an example, not very big, not super deep, but it took me about an hour to do for the simple fact that it was on the front of the quarter panel. super limited access, could only get to half the dent and had to try to glue pull the other half. Still super happy how it turned out! PDR takes an insane amount of patience.