Jim's Auto/Truck Custom Fab

08/03/2026

08/02/2026

Clifford is back up and running!! It's been meny years sitting. Still have a few more things to do but the hard part is done!!

07/26/2026

Finly got a metal brake!! This will make bending so much easier and faster, Then using an angle iron on the side of a bench. Going to build a stand with some casters.

07/24/2026

1970 Datsun 240z. Suspension, crossmember and gasket work, adjust the clutch.

07/24/2026

34 ford, having a over heating problems and vacuum leaks. Some one used way to much Silicone, no no no🤦🏼‍♂️. Love working on old school when things made sense. After I'll be adjusting the carb, and see if there's more in timeing I can add to squeeze out a little more power.

07/24/2026

34 ford. Nice little car. Some engine work, with timming and carb work.

07/11/2026

She is alive!! Still have a long ways to go before it's ready to go to its owners.

07/10/2026

Fist time working on a Pontiac fiero. Let get her running, driving and stoping.

06/25/2026

Built a fan shroud with two 12" Spiral fans for a mazda RX-8 with a nissan skyline engine swaped. Car came to me none running and been sitting 6-7 years. Got it running with new injectors, new fuel lines, and fresh Ethel fuel, and installed a base tune, because the file on the fuel tec ECU was corrupted from sitting to long. Now she's at a turning/dyno shop. Still waiting on them.

06/25/2026

Well let's play with a shifter cart. Engine had no compression., and the oil crank case was full of water too. Need to be rebuild. Guy my Customer got it from said he will rebuild it the engine. While that's getting done well just slap a predator engine on for now. I'm looking forward to work on this Monday!