A Body Shop in Post Falls

08/06/2026

Don't forget!!!! We do small parts sandblasting! We use a finer sand than the "big guys" so the parts are ready to prime/paint after blasting. We also can epoxy prime the parts if you want!

07/31/2026

Been working on this nice older Chevy truck. There were rust issues with floor and rocker. The inside of the rocker was so clean--cleanest and rust-free that we've seen in a long time--so Dan decided to trim the new rocker instead of removing the whole thing. Got the inner rocker installed. I (Julie) am working in welding the trimmed rocker today. I like to make several tack welds then grind them rather than grinding one huge continuous weld. It helps me find pinholes. Just the way that works best for me🙂

07/22/2026

We've been busy so I haven't had much time to post. Today I welded in a patch piece on part of the trunk floor. Of course I had to do this on the hottest day of the year so far🥵🤪

07/14/2026

Wow!!! Thanks to all of our friends and followers we made it to over 1000 followers!!!🎉🎉🎉👏🏻👏🏻👏🏻👏🏻 Thank you all for your support!!😊

07/11/2026

Wheel cylinder went bad so having to replace it on my (Julie's) '75 CJ6🫤

07/06/2026

Finished welding the floor cracks around the seat mount. It'll get epoxy primer and a little paint.

07/03/2026

07/03/2026

Prepping to weld the cracks on an older Blazer's floor. I drilled the end of the cracks with a 1/8" drill bit so they won't continue growing. Got some nice hot, flat welds on this one. I like to grind the welds as I go instead of welding the whole thing and then grinding. Just the way that works for us!🙂

07/02/2026

Started stripping the paint off of this old car. I check to make sure I'm not getting too hot. I'm using the Eastwood SCT Contour tool with the black fiber drum. I've found it's the best to strip paint and filler

06/30/2026

Pulling out a slight door crease with the dent puller