Spitfire Automotive

07/22/2026

07/22/2026

We got Brandon Tanny right with this one. A small lift and fresh tread makes all the difference.
Brandon called us up looking for a more aggressive tire while retaining function for his business and we did not miss.
2 inch full lift kit provided by Rough Country and some 33 inch Falken Tire wild peaks to finish it off 👌🏻
Best part zero rubbing.
Check out Tanny Spa Acquisitions for your hot tub needs.
Race cars, maintenance or trucks we got you 🙏🏻

04/15/2026

Getting this project wrapped up. Looking forward to the drift season and running some laps.
What car would you drift if you could pick one.

03/21/2026

New spitfire build. E46 drift car.
Any interest in drifting?! Mustangs bmws Zs infinity we've got your back. Very excited to reveal this build.
Dont be a stranger stop by!

04/12/2023

Beautiful G35 in and out with a JDM vq35 swap in a USDM car.
•Owner
Installed:
• lightweight flywheel and 1 piece driveshaft
• short shifter
• 6 puck clutch
duckbill carbon trunk
When you’ve worked on a specific platform for so long, you get to a point where you think you’ve seen it all. Car arrived setting CKP sensor codes due to the JDM motor having incorrect air gap spacing for the crank sensor. We fabbed up a .80mm spacer, and alleviated that issue; along with the crankshaft set up to properly mate to a manual transmission.

03/29/2023

The fab departments been busy we see!!

“WHAT WE ALL BEEN WAITING FOR !!

Introducing the 2019 RZR Turbo 2.5" Stainless Valved and
symmetrical tipped exhaust!

Constructed out of all stainless pie cuts and bands from

A valved Y split to allow the best of
both worlds for our client! Meticulously TIG welded and fit to perfection!

As always using the correct equipment for the job i stuck with my #20 .australia teflon cup which just makes honestly any aspect of welding and fabricating a breeze!

A special shoutout to for the filler rod and tungsten stock up to complete this project, as well as a huge
thanks to for all of the insight they offer, and for any last minute parts/installs etc.

Overall ive had quite a few hours into this and id be interested in creating a kit for it, granted being the price of what this one was i will make a jig and reduce the price point down.

If you're interested in an exhaust like this for your Polaris RZR message us to get a consultation started!

SOUND CLIP COMING SOON!!!!”

welder: Swervin Ervin at

•
•
•

03/20/2023

This beautifully kept c5 in for some brake system upgrades along with a MUCH needed brake flush in prep for the new season! Don’t wait until the last minute, the spring rush is coming!
•
•
Owner

11/18/2022

Mustang in for some general repair and maintenance before getting put away for the season 🥲 on a side note, we also would be more than happy to service your winter vehicles even if it is just a point A-B be**er 😇
•
•
•