Cannon’s Performance Engines

Cannon’s Performance Engines Engine building service located in Central Florida
Multiple years of mild performance and marine re

Wrapping up another heads and cam swap with low mount AC bracket and power steering / alternator brackets.
09/23/2023

Wrapping up another heads and cam swap with low mount AC bracket and power steering / alternator brackets.

Setting up a fresh set of nickel chrome stones for this head getting titanium valve train
08/16/2022

Setting up a fresh set of nickel chrome stones for this head getting titanium valve train

Set of 170CC 302 heads came in for intake valve replacement. Seats ground and new valves lapped to each seat. ...
07/03/2022

Set of 170CC 302 heads came in for intake valve replacement. Seats ground and new valves lapped to each seat.

06/28/2022

‘s heads / cam swapped 6.0 from earlier this month getting used the right way

Quick cam and heads swap on this 6.0. Went from a 228R to a cam and 243 heads replaced with 823 rectangle port heads. ...
06/13/2022

Quick cam and heads swap on this 6.0. Went from a 228R to a cam and 243 heads replaced with 823 rectangle port heads. F body oil pan installed, and an inspection for anything out of ordinary

3-angle valve seat cut and refaced valves along with resurface done for a 6.0L coming together soon
05/14/2022

3-angle valve seat cut and refaced valves along with resurface done for a 6.0L coming together soon

Haven’t knocked out a set of freeze plugs since I was a year down grunt at the first machine shop that would give me a j...
12/30/2021

Haven’t knocked out a set of freeze plugs since I was a year down grunt at the first machine shop that would give me a job 😤 didn’t miss it.
Wash, hone, New cam bearings, and freeze plugs in block

Appreciation post for this adjustable Cornwell balancer puller that works much better than the design next to it. Hardly...
12/07/2021

Appreciation post for this adjustable Cornwell balancer puller that works much better than the design next to it. Hardly cost any more than the other one too. The foot on the end of the bolt is actually big enough it won’t walk all over the end of your crank and tear it up and it doesn’t flex and bend when you use it.

cam going in an otherwise stock 6.0 getting some re-done 243 heads and LS2 Bolt ons
12/05/2021

cam going in an otherwise stock 6.0 getting some re-done 243 heads and LS2 Bolt ons

LS3 heads cleaned, resurfaced, and dual springs retainers and seals installed.
11/03/2021

LS3 heads cleaned, resurfaced, and dual springs retainers and seals installed.

New cylinder head install on a Checked the deck for straightness, new ignition coil, switch, plug, etc. will be conv...
09/13/2021

New cylinder head install on a

Checked the deck for straightness, new ignition coil, switch, plug, etc. will be converting to flywheel with ring gear as engine came with electric start but has a pull start flywheel 🤨

One broken exhaust bolt out, one more to go on a customers set of 243 heads going on a new build
08/30/2021

One broken exhaust bolt out, one more to go on a customers set of 243 heads going on a new build

Address

1625 N Magnolia Avenue
Ocala, FL
34475

Telephone

+13528172020

Website

Alerts

Be the first to know and let us send you an email when Cannon’s Performance Engines posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Cannon’s Performance Engines:

Shortcuts

Share

Category