01/18/2026
We’ve got some end of season parts for sale.
Procharger F3R-102 has approx 15 runs on it since being freshened up by Procharger. Includes air inlet bell (does have a slight bend on it), screw on Wiggins adapter (Motion Raceworks fl**ge) and brackets to adapt to a Supercharger store gear drive. Made 44psi on my 427sbf and went 4.28@ 169 or 6.70 @ 207mph at 2950lbs 2000hp. $3950
Procharger 5” inlet bell for F3D 102/106 mint. $175
Procharger F3 series blower deive hub keyed $150
Procharger bypass valves (race style with single oval outlet) x2 available $200ea
2 speed TH400 freshened by Proformance Racing. 1 3/16 input shaft, 1.48/1.0, aluminum drum, Griner brake, GM Ultrabell and tail housing, Moroso deep pan. Setup for external dump (not included), clean neutral. Includes PPP shifter and cable. Easily support 2000+hp $6250.
Also have 1.34 TH400 gearset can be included above or separately $800
8 - Billet Atomizer 3 700lb Injectors with 4 passes only, cleaned and pickled in the original case $1250
66” wheelie bars fully welded up with brackets, ready to be welded on $300
Waterman BBC fuel pump drive kit new $300
Mezeire 300 BBC electric pump in black/polished new $450
Reese bolt in bed 5th wheel 16k barely used $375
Misc used BBC parts - Isky Lifters $200, Tilton Starter $150, ATI Damper $200
16V Lithium charger new $200
Mustang fiberglass small cowl with dzus (has hole cut for clearance) screened over $125 and decklid with custom strutless wing from Larry Jeffers $150
ATI Trans Vent $50
Bolt on weight bar with twin screw on lids for lead shot. Can hold - up to 20lbs great for front of car or JR dragster
Edlebroack 7709 heads, will need decks welded, surface and new valves. Have good PSI springs, Ti Retainers and Jesel shafts. Flow 360ish cfm. $1250 takes it all
Holley SBF 300-242bk Hi-Ram black with 105mm lid, fuel rails included. Has been ported so would prefer it be checked to your heads before purchase (can epoxy back as needed) $700
Mustang V8 spindles $125
9” Fab housing setup for ladder bars for Mustang $425
Shelby Solid Aluminum SBF block. Could be cleaned up slightly for sleeves, will need main work due to spin bearings. Minor rough spot inside to due aluminum rod break, 55mm roller cam tunnel. $3500.
Pics or additional details are available for anything. Prefer local sale however will box/ship on your dime. Open to possible trades if there’s something im needing…golf cart, 69 Camaro or LS parts,

