Fueled Creations

08/06/2026

Picking up 2 sets of bag mounts from our guy at Grimes Metal Work n hoping to have them welded up today (long as it stays dry) n have them shipped out by friday if all goes right! Thank you guys for the business and if anyone else is needing bag mounts or shock mounts for your 03+ crown vic/swap, just message us!

07/30/2026

These work wonders! Along with his 5in extension shafts for the 22mm rollers is a must! We use both and have his dimple dies as well and have been great for a few years now!

2- 22mm delrin stencil dies for 22mm bead rollers. $50 each, $90 for the pair.

07/30/2026

If you like podcasts and f100s, go check out Ford f100 World, Craig talks with alot of good people on there and alot of different content!

07/28/2026

Well our 03+ Crown vic air bag mounts are done...we have corrected the bag angles as much as possible and are now parallel at 70-80psi vs 90-95psi which is how all the ebay/amazon bag mounts are and dont have crazy bag stretch like the amazon/ebay specials i posted. These are tested on aluminum lowers while steel arms i believe will need a simple trim of the lower plate arms to fit, Soon as i 100% verify that, we will set them up for steels as well so you dont have to.

These will be $200 shipped and will be fully welded and ready to bolt in...if you pair these with our 03+ shock mounts ($275) you will have all new grade 8 hardware also and we will bundle these to $435shipped to the lower 48!

Like all our parts, it will have a 1-3week build time
Venmo and PayPal ready
Send me a message and i will get you taken care of

As always thank you for the support
Like share n follow

07/24/2026

Well after alot of trial n error, I have the bag mounts fully changed and have them sitting good for a 75-80psi ride height! Both the upper mount and lower mounts got angle changes to allow the bag to sit correctly! The whole market on these where based of the Original BYC mounts and while they did fit the best, they still where not correct unless you stayed at 95-100psi which is where it has the least amount of camber with factory arms

07/23/2026

Its been a day long of test fitting all my bag mounts and finding CORRECT angles! These are the original setup i have on my truck n ran for the past 5 years w/o issues....that being said, while these are 10x what is out there now, with our set, im going to correct this even more! Goal is to set these so the bag is sitting straight at around 75psi vs 90-95psi like these are!

Comment and let me know what psi your CV is running at RIDE HEIGHT and tire heights/size so I can get a more accurate number...most are not going to be the same but I feel average is about 75psi but with a CV 90-95psi has way less camber n a reason I personally run it cause tires aren't cheap hahah