10K Technology

06/02/2026

Giving the hub dyno a little exercise today!
Twin Turbo, Methanol BBC ready to do some work!

05/19/2026

How much extra Valve spring "pressure" do you need when you add boost?

Listen in as myself and Brian Wolfe discuss his 1900 HP Twin Turbo Godzilla engine and explore some actual in-cylinder pressure traces from a 5000+ HP Promod engine!

https://vimeo.com/1193687733?share=copy&fl=sv&fe=ci

05/06/2026

Super Summer Blowout Sale!

Godzilla 511” Stroker Kits are ON SALE NOW at

https://10k-technology.com/products/511ci-stroker-kit-ford-godzilla-rotating-assembly

Limited Supply…when they’re gone they’re GONE!

05/04/2026

Making some locators for the Godzilla to fit our TK-545 Springs this morning…

Brian Wolfe inspired me so we will dyno them this afternoon!

Get yours here: https://10k-technology.com/products/tk680-16-conical-valve-spring-set

04/29/2026

If you missed the video…
Here it is again in an article from EngineLabs!

Valve spring measurements are a critical part of properly setting up a high-performance, high-RPM valvetrain.

04/20/2026

Our Conicals will outperform just about any similar dual spring out there!

More rate = higher frequency = higher RPM capabilities!

Get yourself some today!

https://10k-technology.com/products/tk680-16-conical-valve-spring-set

04/15/2026

Are you a Control Freak?

Then you need some Ovate Wire Conicals for .675+ lift hydraulic and solid cams!

https://10k-technology.com/products/tk680-16-conical-valve-spring-set

Our Mission: Offer the highest quality parts while providing the knowledge and support to truly understand what it is you're receiving and what you should expect of it!

04/15/2026

The RangerZilla got a serious upgrade on the front end with custom valving on the Penske shocks by Chris Bell at Kinetic Engineering!

This should help control the 800 HP 511” Godzilla under the hood when it hooks up!

04/14/2026

+.050 Locks are BAD???

Here’s the rest of the story!

04/13/2026

How to setup and “tune” your Conical Springs for maximum performance!

Installed height, distance to bind are way more important than getting the loads to be a certain number on the seat and over the nose…

Here are the things that matter most and what you can do about adjusting them to fit your project!