04/07/2026
The "it was working fine yesterday" starter pack. 🛠️⚠️
🚫 The Hall of Shame:
-Household Wire Nuts: These belong in your kitchen ceiling, not on a boat.
-Electrical Tape Overload: Tape is a temporary fix, not a structural component. Underneath that sticky mess is usually a recipe for a short circuit.
-Missing Internals Fuse Holders: If your electronics are flickering or cutting out, check your fuse and the holder inside and make sure everything is clean and in this case, there at all.
-Is than an extension cord??!!!!??
✅ The "Do It Right" Checklist:
Marine-Grade Heat Shrink Connectors: Use tinned copper connectors with adhesive lining. When you heat them, they seal out the moisture.
Proper Crimp Tool: Don’t just mash it with pliers. A dedicated crimper ensures a mechanical bond that won't shake apart when you're hitting wakes.
Dielectric Grease: A little dab in that fuse holder goes a long way in preventing the corrosion seen in the third photo.
Fix it right once, or fix it at the boat ramp while the fish are biting elsewhere. Tight lines and stay grounded! 🎣⚡
