Westside Motorsports

Westside Motorsports I am an accredited and certified MMI grad with 10+ years dealership and multiple years independent.

Full house this morning. Had to put the Crf250 on hold. Helped out some neighbors from the Great White North with a rear...
09/03/2026

Full house this morning. Had to put the Crf250 on hold. Helped out some neighbors from the Great White North with a rear blowout on a Harley. Safe trip to Vegas fellas!

Coming to the end of day 2 on this crf250x. Starting to look like a bike again. Hopefully it'll be finished tomorrow. Di...
09/02/2026

Coming to the end of day 2 on this crf250x. Starting to look like a bike again. Hopefully it'll be finished tomorrow. Did the topend, replaced the waterpump drive and driven gears, and rebuilt the carb. All that's left is to finish the reassembly, wiring, add oil and coolant, rebuild the forks, and run it a bit before the customer gets a rather fresh bike back.

Why are you booked out for so long? Well..... because I gotta fix all of this. 😆 🤣
09/01/2026

Why are you booked out for so long?
Well..... because I gotta fix all of this. 😆 🤣

Well it's coming together nicely.
09/01/2026

Well it's coming together nicely.

More fun with discontinued and unavailable parts! Had to purchase a used tank for a fella with an old Arctic Cat. Appare...
08/28/2026

More fun with discontinued and unavailable parts! Had to purchase a used tank for a fella with an old Arctic Cat. Apparently didn't flush the tank thoroughly enough. Got it running but it kept falling on it's face when I gave it throttle. Thought it may be the ECM but it wasn't. It was what is pictured below. This small amount of crud will reek havok in a carburator. Again, if you purchase used parts because you absolutely have to in order to keep your old machines running, be prepared to repair said parts you order.

Oh the peril of buying used parts online. Back story: Purchased a complete engine from ebay because a vandal fill this o...
08/28/2026

Oh the peril of buying used parts online. Back story: Purchased a complete engine from ebay because a vandal fill this old engine with water. The crankshaft was seized and the piston was rusted to the cylinder. The listing said it had good compression. Well it had 62psi. The spec is 180 to 185 psi. Not good. Piston rings are siezed in the ring lands. Luckilly I found a new piston at a dealership in Texas. The new rings and all related parts were sourced on ebay as this 1983 Honda doesn't have parts available anymore. The seller worked with me and gave me a partial refund to pay for new parts. Moral of the story, be ready to repair used parts purchased online.

Gasket time again
08/25/2026

Gasket time again

100% improvement! And this gentleman is safe to finish his trip. Thanks Mr. K. for your business and safe travels when y...
08/24/2026

100% improvement! And this gentleman is safe to finish his trip. Thanks Mr. K. for your business and safe travels when you head back to Canada.

08/22/2026

My money is on piston slap. Either way, it's not good.

Won't be flushing these non working brakes. The bare minimum will need the master cylinder rebuild. Probably an entire f...
08/21/2026

Won't be flushing these non working brakes. The bare minimum will need the master cylinder rebuild. Probably an entire front brake system overhaul is needed.

Address

504 Central Avenue West
Great Falls, MT
59404

Website

Alerts

Be the first to know and let us send you an email when Westside Motorsports posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Westside Motorsports:

Shortcuts

Share

Category