JLopez Mechanic Services

JLopez Mechanic Services Mechanic Work

The owner of this 95 ford bronco brought me his truck because it was hesitating on acceleration. So I checked the timing...
01/17/2024

The owner of this 95 ford bronco brought me his truck because it was hesitating on acceleration. So I checked the timing and it was off so I adjusted the timing back to 10 degrees BTDC at idle. I also did some tune up work that the owner approved replaced the distributor cap, rotor, wires, and plugs. Fixed up and ready to go✅

This 2000 Lexus rx300 had a few codes that turned the check engine light on and made it have drive ability issues .. I t...
01/03/2024

This 2000 Lexus rx300 had a few codes that turned the check engine light on and made it have drive ability issues .. I tested the vvt solenoid and it was not functioning properly also the car had a code for malfunctioning IAC valve and I found that one of the pins in the connector was broken not making good contact ✅

This 2018 Dodge Journey had a drivers side window that wouldn’t go up or down after looking into it I found some broken ...
08/03/2023

This 2018 Dodge Journey had a drivers side window that wouldn’t go up or down after looking into it I found some broken wires .. fixed the wires and got it working ✅

08/03/2023

Some work on this 2008 Tahoe the lifter failed and with the damage to the lifter I thought for sure the camshaft would need to be replaced but surprisingly it didn’t look too bad so I replaced the lifter and put in new lifter tray and all new gaskets got it running right ✅

This 2016 Jeep Patriot had an ac compressor with internal damage so I installed a new one for the customer and also a ne...
06/24/2023

This 2016 Jeep Patriot had an ac compressor with internal damage so I installed a new one for the customer and also a new ac condenser and drier and all new o-rings and I got it blowing COLD🥶for the customer in this heat 🔥✅

This 2016 Chrysler 200 was overheating fut to a coolant leak from the radiator.. so I got a new one installed for the cu...
06/06/2023

This 2016 Chrysler 200 was overheating fut to a coolant leak from the radiator.. so I got a new one installed for the customer ✅

This 07 pathfinder was brought to me after the customer tried to fix it himself and had no luck .. so i scanned the vehi...
06/06/2023

This 07 pathfinder was brought to me after the customer tried to fix it himself and had no luck .. so i scanned the vehicle and got a P0300 code so I did a smoke test and found some vacuum leaks I fixed them but the car was still rough idling and not accelerating so I removed the catalytic converter and found it was clogged so I cleaned it out and got it running right again ✅

This 05 Ford F-150 had some overheating problems but the customer had already installed a new radiator and there were no...
06/06/2023

This 05 Ford F-150 had some overheating problems but the customer had already installed a new radiator and there were no leaks .. so I took a look at the coolant and it was very old dirty coolant so I flushed the system and added fresh coolant

06/06/2023

This 03 Chevy Tahoe was brought to me because the customer said the brakes weren’t working well and the pedal would go all the way to the floor .. so I started looking for leaks and I found it once I fixed the leak I added fresh brake fluid and bled the brakes ✅

This 07 suburban was brought to me because the customer said he noticed the wheel wasn’t straight it was at an angle and...
06/06/2023

This 07 suburban was brought to me because the customer said he noticed the wheel wasn’t straight it was at an angle and wanted to get it checked out after looking at it I noticed it had too much play in the upper ball joint so I swapped it out with a new one and while I was doing the work the customer wanted to go ahead and also replace the lower ball joint as well ✅

This 2010 dodge ram had a coolant leak from the radiator so I changed it out for the customer, and while I was there the...
04/27/2023

This 2010 dodge ram had a coolant leak from the radiator so I changed it out for the customer, and while I was there the customer also decided to change the serpentine belt ✅

Some work from today on this Honda accord changed out a hardline that was damaged on the rack and pinion To get to the l...
04/27/2023

Some work from today on this Honda accord changed out a hardline that was damaged on the rack and pinion
To get to the line I had to remove the transmission mount and while I had it out the customer decided to change it out also ✅

Address

Eagle Lake, TX
77434

Opening Hours

Monday 3pm - 7pm
Tuesday 3pm - 7pm
Wednesday 3pm - 7pm
Thursday 3pm - 7pm
Friday 3am - 7pm
Saturday 3pm - 8pm

Website

Alerts

Be the first to know and let us send you an email when JLopez Mechanic Services posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category