05/17/2023
A Guide to Prep Your Boat for Summer
Summer season, and therefore boating season is about to be upon us! As a boater, you must be sailing on water instead of being drowned neck-deep into fixing your boat. However, it is a crucial exercise every boat owner must adhere to. You must wash your boat, top-on all fluids, and oils, and inspect your propellers. Running fresh water through the outboard is a must.
When it comes to the engine, you must ensure to change the following
Lower unit grease
Spark plugs
Waters pumps
4-stroke engine oil every 100 boating hours
You must also check the bunks and rollers on your trailer. Make sure that the rollers are spinning freely. You must fix all tears and holes on the bunk carpet. Make it a practice to check your trailer, hull, and props after every run on the water.
Here is a list of some critical inspection tasks and their frequency.
Oil and Filter Change
You must change your oil and filters every six months or after every 375 boating hours. (Whichever benchmark you reach first)
Fuel Filter
Change these filters every 12 months or after the completion of 100 hours of boating.
Water Pump Service
Service them every two months or after completing 200 hours of boating.
Transmission Oil
You must change your transmission oil once in 24 months or after the completion of 2000 operational hours, whichever benchmark you reach first.
Drive Belt
It should be inspected regularly and changed every 12 months or upon completion of 1000 hours of operation.
Flush Cooling System
This activity can be conducted every 72 months, or upon completion of 6000 hours of operation. However, you need to inspect it for regular maintenance.
Clean Air Filter
Clean them every six months or after 1000 hours of operation.
Steering Cable Grease
You must grease this one up every 12 months. A recommendation is to do so at the beginning of the boating season.
Battery Charge
You can do this either every 12 months or if the battery indicator shows low sign. Sometimes battery charge can drop due to no-use. So, stay on top of this if you do not want to get stuck in the middle of no-where.
Check Prop
This one is a no-brainer. It is a pre and post check for each time you take your boat out for a spin.
Summer Start-up Checklist
Apart from the above mentioned long-term inspections, here is a detailed checklist of what you must do to get your boat ready for summer.
Fuel System
Inspection of your fuel system for damages, leaks.
Inspect fuel tank surface, connections, and hoses. Any softness cracks or brittleness on the hoses jeopardizes its structural integrity.
You must replace components as and when needed; additionally, always ensure that all the clamps, nuts and bolts, are in place securely.
Ensure the engine, ventilation, and exhaust systems are in working order.
Clean your carburetors thoroughly. When working properly, a marine quadrajet carburetor ensures a healthy fuel economy and emissions for years and avoids problems like hard-hot starting, rough idle, stumble under load, or flooding.
Cables and Belts
Belts and cables are prone to cracks and brittles during the winter season; therefore, conduct a thorough inspection.
The belts must tightly fit around the pulleys. It is important to prevent slipping.
Another sign of a worn-out belt is it will leave black residue around the pulley.
Swelling on the outer jacket of the throttle, steering control cables can result due to internal corrosion, and may cause imminent failure.
Fluid Levels
You must always check all fuel levels. It includes power steering, engine oil, power trim reservoir, and coolant.
Always ensure to change oil filters, drive lubricants, and engine oil in a timely fashion. Especially if these were not already taken care of before you kept the boat way in winter storage.
Electric System
All electrical systems must be inspected by a qualified electrical technician, preferably someone with experience.
Do not forget to remove corroded terminals.
Use a wire brush to clean the terminals and cable ends.
You must check all electrical connections for corrosion. It can be very detrimental.
Always charge your battery at the beginning of the season. It is also crucial to have it tested to make sure it can hold a charge in full capacity.
Hulls and Props
These are very important:
You must conduct a thorough inspection of your propellers for cracks, pitting, distortion, and dings.
Replace the propeller bearing if needed, and ensure that the propeller is securely in place.
A damaged prop can result in unwanted vibrations and damage your drive train in the worst-case scenario.
While you inspect your hull check for cracks, distortions, and blisters, you must clean the hull, topsides, and deck with an environmentally friendly cleaning solution.
Safety Gear
Check your life-saving gear such as life jackets. Make sure they are in good condition, and most importantly, there are enough for every passenger on board.
Ensure you have an appropriate life jacket for each passenger on the boat, which means the correct size for their respective bodyweight.
Consider EPIRB to tackle distressful situations. It makes it easier for the authorities to find you.
It is always a good idea to take advantage of any inspections offered by agencies, such as USCG Auxiliary, US Coast Guard, and US Power Squadrons.
