Project Scrambled

09/03/2026

Project Scrambled,
Just some fun clips.

08/31/2026

08/31/2026

Bee goes to the domes!

08/25/2026

Scrambled gets a Toterhome!

08/24/2026

Scrambled,

Playing around with AI generated photos.

08/24/2026

Scrambled,

A stroker 417 heartbeat!
After a long delay I was able to get back on track and get this beast built!

05/19/2026

Scrambled,

Today was a good day for Scrambled,
Main bearing clearances are dialed in!

It took some moving of the bearing shells around to achieve a balanced clearance but they are all sitting at .0020.

Once that was done I pulled it all back apart and removed the crankshaft and cleaned out all the bearing saddles, shells, and crankshaft.

The cam shaft I had the machine shop set up so no worries with it.

Next up is cam and crank install!

Cheers,

05/18/2026

Scrambled,

Today was fun till I realized I made an oops!

I miss read the specs and used plastic gauge of the wrong size so when I went to check bearing Clarence everything was way tight👀

Well at least I got some good practice with the torque and angle wrench, always a bright side! 😉

Also the head gaskets finally come in. 🤞I did the math correctly. Time will tell….

Cheers,

05/09/2026

Rusty took its first ride of pride on the trailer,
I didn’t want to risk burning up the transmission.
Super weird issue, the transmission cooler inside the radiator popped and let coolant and transmission fluid mix and off course made a mess.