Clayton & Son's Fabrication

Directions

Clayton & Son's Fabrication Family owned automotive repair, fabrication and welding services

Here are some new aluminum side boxes to replace rusted out steel ones on this wrecker body
08/11/2026

Here are some new aluminum side boxes to replace rusted out steel ones on this wrecker body

Straight pipe into a new dual tailpipe kit and some new used shorty headers installed on the 2016 Silverado
08/11/2026

Straight pipe into a new dual tailpipe kit and some new used shorty headers installed on the 2016 Silverado

This trailer received some much needed repairs. Along with some new tires, decking and ramps
08/11/2026

This trailer received some much needed repairs. Along with some new tires, decking and ramps

Here's the completed front bumper and receiver mount for a winch on the 3rd Gen 4Runner. Also installed some new off roa...
08/11/2026

Here's the completed front bumper and receiver mount for a winch on the 3rd Gen 4Runner. Also installed some new off road lights.

Swapped out the K frame on this race car. The old one was rusted out, causing the CV shaft to come apart
05/24/2026

Swapped out the K frame on this race car. The old one was rusted out, causing the CV shaft to come apart

This 3rd Gen 4 Runner came in for a suspension lift swap out, 2" body lift, new front cv shafts, valve cover gaskets, ca...
05/24/2026

This 3rd Gen 4 Runner came in for a suspension lift swap out, 2" body lift, new front cv shafts, valve cover gaskets, cam plug seals and intake gaskets. Still need to modify/fabricate a custom front bumper.

Cracked aluminum wheel? Reach out to me to see if it's repairable like this one
05/24/2026

Cracked aluminum wheel? Reach out to me to see if it's repairable like this one

Customer had lost the track on his snowmobile. When the track came apart, one of the studs put a hole in the heat exchan...
05/24/2026

Customer had lost the track on his snowmobile. When the track came apart, one of the studs put a hole in the heat exchanger/tunnel. I had to remove the rear skid and drive shaft, along with the majority of the sled from the top half in order to repair the hole. Once all welding was complete, i did a pressure test to ensure a leak free repair. Sled received several new seals, bearings, a new studded track, and had a full service of all fluids.

This Jeep Wrangler was due for all new front end parts
05/02/2026

This Jeep Wrangler was due for all new front end parts

Recently completed a full service of all drivetrain fluids, new axle seal and rear brakes on this 2014 Silverado. Also i...
05/02/2026

Recently completed a full service of all drivetrain fluids, new axle seal and rear brakes on this 2014 Silverado. Also installed a new set of side steps

Address

221 Cram Street
Bradley, ME
04411

Website

Alerts

Be the first to know and let us send you an email when Clayton & Son's Fabrication posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category