Backyard Fab

Backyard Fab this page was created to share my progress with interested people about current and future builds.

Finally got the new frame mounts installed. Still had to modify the block brackets to fit where I wanted the motor sitti...
09/14/2024

Finally got the new frame mounts installed. Still had to modify the block brackets to fit where I wanted the motor sitting at. Next up is making a transmission crossmember.

photo dump from the first day of ls fest.
09/06/2024

photo dump from the first day of ls fest.

New muscle car oil pan and dirty dingo mounts installed.
09/03/2024

New muscle car oil pan and dirty dingo mounts installed.

Finally got to the point I'm almost ready to drop the motor and transmission in so I can start mocking up the rear end
09/02/2024

Finally got to the point I'm almost ready to drop the motor and transmission in so I can start mocking up the rear end

Finally finished the other side of the frame notch. More clearance and a lot stronger than it was before.
08/03/2024

Finally finished the other side of the frame notch. More clearance and a lot stronger than it was before.

One side wrapped up. Just need to smooth it out and polish it up.
07/28/2024

One side wrapped up. Just need to smooth it out and polish it up.

Not my best tig welds but it's got dam good Pe*******on. I'm gonna run one more final pass to put a cap on it once it co...
07/21/2024

Not my best tig welds but it's got dam good Pe*******on. I'm gonna run one more final pass to put a cap on it once it cools

Well let's hope I did the math right and I undercut this. Taking a cutoff wheel to a axle tube is a bit nerve-wracking
07/21/2024

Well let's hope I did the math right and I undercut this. Taking a cutoff wheel to a axle tube is a bit nerve-wracking

Another score for the pull a part in Nashville. 145$ 8.8 to go in the s10.
07/20/2024

Another score for the pull a part in Nashville. 145$ 8.8 to go in the s10.

Trying a repair process I found on YouTube. So far it seems to be going pretty good. Won't know till the finished produc...
06/29/2024

Trying a repair process I found on YouTube. So far it seems to be going pretty good. Won't know till the finished product but I'm hopeful for now

Snagged this from the pull a part in Nashville yesterday. Only one Crack Is pretty dam good.
06/23/2024

Snagged this from the pull a part in Nashville yesterday. Only one Crack Is pretty dam good.

Address

Bowling Green, KY

Website

Alerts

Be the first to know and let us send you an email when Backyard Fab posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category