Mills Automotive Repair LLC

10/09/2026

When’s the last time you got your air intake system thoroughly cleaned real well. Get with me today about getting on the schedule to deep clean your intake and valves of all the built up carbon today!! Running a special on cleanings!!!

10/09/2026

Here’s one for yall that I did this evening. Started on this 2012 F150 5.0 yesterday evening with a Crank No start issue . So found the truck to not be getting fuel which was a faulty fuel pump driver module. Replaced with new part and still had a crank no start problem but we had fuel this time. After a couple hours of diagnosing, I found this lil guy to have a broken leg which was not getting a connection. This little fuse is to the ignition coils, found it to be like this after I tested my no spark diagnosis with pulling a coil and spark plug to test for spark. There was no spark on any of the coils. Swapped the fuse with another 15A fuse and vehicle fired right up. Customer and I were very happy to know it wasn’t anything further or major.

10/02/2026

Busy day in shop today, coolant hose replaced, carb work, front wheel bearing and spindle assembly replacement.

09/29/2026

Is your car acting weird lately with throwing a bunch of codes, lights on the dash, or even have the transmission quit shifting out of no where???? Chances are that your vehicle may have a battery or charging issue. That’s what happened with this van, it came in with lots of issues and after diagnosing that the alternator had a broken plug connector. So I replaced the alternator and I restored and charged the battery that was completely dead, everything started working again. Thank you for your business!!!

09/23/2026

Slackin a little bit. Got this customer fixed up late this evening with some new front end parts. CV Shaft (which was just barely holding together), stabilizer links, and front rotors and pads.

09/18/2026

Front end work Friday!!! Putting on some new parts here and will go to tire shop on Monday for new front tires and an alignment since I do not have a tire machine and equipment or an alignment rack and machine.

09/14/2026

Little Monday evening job

09/12/2026

09/11/2026

Good morning everyone, getting some work done in the shop with some wheel bearings.

09/02/2026

Thank you all so much, we have reached 500 followers and gaining more. Our next goal is 1,000, thank you all for the support and love along the way.