Reb 6

19/02/2026

Port match on carb body!

19/02/2026

Port match on big half malossi 177 cylinder

19/02/2026

Port match malossi 177 cylinder

19/02/2026

Using an angle grinder to modify a crankshaft is not for the faint of heart! The objective is to advance the inlet opening as well as inlet duration demanded by the cylinder kit.

18/12/2025

30/11/2025

Plug read of this engine after two weeks from first start and road test. . Malossi 166 matched ported to case, Malossi intake manifold with Dellorto PHBH 30mm round slide partnered with JL expansion pipe and 2% pre-mix oil in tank. Standard ignition set at 18’ BTDC! Jettings and setting of carb will not be disclosed at this time. What do you think?

16/11/2025

Needle was advanced/rich at 1/4 to 1/2 throttle before, adjusted it today. Let’s see.

10/11/2025

Needs a bit of tuning at 1/4 to 1/2 throttle position at the moment! Needle selection and position is vital.