OCD Performance NZ

25/05/2026

Cheers to for bringing his RX-3 through recently for a full rewire.

In went a G4X Fury and motorsport spec loom to run the new turbo motor, a Blackbox P30 PDM and new chassis loom to do away with all the fuses and relays and run fans, fuel pumps, water pump etc, a microtech dash install as well as some new car security and speaker wiring while we were there.

Can’t wait to see it out on the streets very soon!

19/05/2026

SR20VET S15 all done a while back for

This one got a a bunch of work including -

⚡️ R3 to run the engine, cooling fan and fuel pumps
⚡️ uC-10 dash install
⚡️ Engine bay fuse box replace and relocate
⚡️ Battery relocation

13/05/2026

I forgot to get a pic of the engine loom 🤦‍♂️ but here’s a couple pics of EVO getting a R3 installed to take care of engine, fuel pumps and fan control, ABS delete retaining ACD and a bit of work on the front end wiring removing anything that doesn’t need to be there including relocating the fuse box and front ecu inside the cabin for a tidy engine bay 👌

05/05/2026

Had this tough VK Commodore through a while back to install a new billet trigger kit, whip up some new ignition leads and wire the direct fire IGN1A coils into the existing system ⚡️⚡️⚡️

#355

21/11/2025

M&W CDI ignition system ready to help a 20B Turbo Rotary make some grunt.

07/10/2025

Haltech Nexus R5 interior loom heading out the door today.

23/11/2024

Steering wheel plate all done to replace an old one that’s seen better days.

11/11/2018

Quick snap of engine loom for the before it gets shrunk up and fitted. 🇳🇿

27/09/2018

Cant wait to work with this PMU! Soon to be in an

29/08/2018