Paterson Auto Engineering

Paterson Auto Engineering Sharing automotive and engineering content

Modifying this RX7 rotary engine housing to accept mechanical temperature gauge 🤙drilled and tapped, and milled a flat f...
26/06/2025

Modifying this RX7 rotary engine housing to accept mechanical temperature gauge 🤙drilled and tapped, and milled a flat for a sealing washer to seat correctly

Now doing aluminium welding 👌 msg the page for any welding requirements. Affordable price's quality service
15/05/2025

Now doing aluminium welding 👌 msg the page for any welding requirements. Affordable price's quality service

L S swap loading 📊📊
13/02/2025

L S swap loading 📊📊

Rusty pipes, every car enthusiast/mechanic will have to deal with this problem eventually if they like tinkering with ol...
13/02/2025

Rusty pipes, every car enthusiast/mechanic will have to deal with this problem eventually if they like tinkering with older cars. Here i warmed up the casting to allow the old pipe to be pulled out and then pressed in the new one i made

I am machining up some 3" body lift blocks today that will pass certification requirements. Most of the body lift block ...
07/01/2025

I am machining up some 3" body lift blocks today that will pass certification requirements. Most of the body lift block kits you can buy online are hollow and will not pass cert

Driveshaft hoop and rerouting brake and fuel lines, just incase if the driveshaft fails under high rpm it doesn't wipe o...
19/09/2024

Driveshaft hoop and rerouting brake and fuel lines, just incase if the driveshaft fails under high rpm it doesn't wipe out the brake and fuel lines, that could certainly make a bad day worse 😬

Today, I'm replacing valve stem seals without removing the cylinder head. I've got compressed air fed into the cylinder ...
26/07/2024

Today, I'm replacing valve stem seals without removing the cylinder head. I've got compressed air fed into the cylinder to hold the valve up. It saves a lot of time 👍

Pressure-testing this carb after a rebuild to ensure the needle and seat are sealing correctly. A special fitting was ne...
05/07/2024

Pressure-testing this carb after a rebuild to ensure the needle and seat are sealing correctly. A special fitting was needed so I could connect my pressure tester. It’s times like this when having a lathe comes in very handy!

Well, well, well! Look what we have here! It's like a carbon party in our engine, and everyone's invited! Shame it's not...
23/06/2024

Well, well, well! Look what we have here! It's like a carbon party in our engine, and everyone's invited! Shame it's not the fun kind of party, though. Time to break out the cleaning supplies.

Address

Palmerston North
4410

Opening Hours

Monday 8am - 4:30pm
Tuesday 8am - 4:30pm
Wednesday 8am - 4:30pm
Thursday 8am - 4:30pm
Friday 8am - 4:30am
Saturday 8am - 12pm

Telephone

+64273892960

Website

Alerts

Be the first to know and let us send you an email when Paterson Auto Engineering posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Paterson Auto Engineering:

Shortcuts

Share

Category