The Pacific Motorcycle Co.

The Pacific Motorcycle Co. Custom motorcycle builders & classic restorations. Cafe Racers, Street Trackers etc, and some rather The Pacific Motorcycle Co.

Based in the sunny city of Nelson, New Zealand, We specialize in building our very own custom motorcycles including cafe racers, flat trackers, brat style etc. In the past we have undertaken classic restorations of Triumph, BSA, Norton, etc.

Some of you will remember this bike as its been in the workshop for quite a while but in a different guise. It's taken a...
14/03/2019

Some of you will remember this bike as its been in the workshop for quite a while but in a different guise. It's taken a more tradition look now with a clubman type seat and a reverse taper muffler in place of the alloy seat and Supertrapp muffler. Intention was to do these and then sell it, but we're quite liking it now....= )

So the latest project to roll out of the PMC workshop is a tad bigger than usual.....Bus conversion to transport three b...
15/01/2019

So the latest project to roll out of the PMC workshop is a tad bigger than usual.....Bus conversion to transport three bikes and up to six old farts that ride / spanner them. There's even a dunny and shower (we're not intending on sleeping in it, that close proximity to that many beer swilling old buggers would be a bit much). In typical PMC fashion nothing was left untouched...

I think some of you may of had insider information...Yip that's a busy looking engine...
16/08/2018

I think some of you may of had insider information...Yip that's a busy looking engine...

These may give the game away...
16/08/2018

These may give the game away...

Any guesses as to the purpose of this assembly? (It's actually "Top Secret" rated but the owner is near computer illiter...
16/08/2018

Any guesses as to the purpose of this assembly? (It's actually "Top Secret" rated but the owner is near computer illiterate so I think we are safe.🙂)

Both high tech and low tech work this week. Low tech - sand bag / hammer, shrinker and english wheel to make a front gua...
06/07/2018

Both high tech and low tech work this week. Low tech - sand bag / hammer, shrinker and english wheel to make a front guard blank. High tech - more cnc goodies in the form of a dash mount and front indicator mounts.

So we had a couple of switch blocks that were manually machined here which I decided to alter in the CNC. Hopefully an i...
26/06/2018

So we had a couple of switch blocks that were manually machined here which I decided to alter in the CNC. Hopefully an improvement.

My least favorite job....wiring...I think it is my least favorite as I don't feel I have nailed the perfect tidy wiring ...
22/06/2018

My least favorite job....wiring...I think it is my least favorite as I don't feel I have nailed the perfect tidy wiring job as yet. Still a few bits to be nutted out on this setup. I like to do the wiring diagram so then I know all the components to be mounted and then do this before running any wires.

Address

18 Barros Place, Richmond
Nelson

Telephone

+64275054442

Website

Alerts

Be the first to know and let us send you an email when The Pacific Motorcycle Co. posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category