XTC Rods and Restoration

XTC Rods and Restoration Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from XTC Rods and Restoration, Automotive Customization Shop, Invercargill.

Well we gave it a shot but just didn't work out as planned. Thanks to our customers and supporters out there, see you ar...
23/10/2017

Well we gave it a shot but just didn't work out as planned.
Thanks to our customers and supporters out there, see you around somewhere.

Single Turbo setup on a 5.3LS in Chevy Truck all done and running, just needs bigger injectors and a stronger trans then...
03/10/2017

Single Turbo setup on a 5.3LS in Chevy Truck all done and running, just needs bigger injectors and a stronger trans then bring on the horsepower!
Next step is tidy up the wiring mess!

Nearly ready. All going to plan in for warrant on Wednesday
27/08/2017

Nearly ready. All going to plan in for warrant on Wednesday

Just a few holes to fill in! All ready for some epoxy primer then smooth it out
10/08/2017

Just a few holes to fill in!
All ready for some epoxy primer then smooth it out

Looked like a good one when it came in but once we stripped to bare metal all it's past sins where uncovered. Still a pr...
29/06/2017

Looked like a good one when it came in but once we stripped to bare metal all it's past sins where uncovered.
Still a pretty good base to start with and once it gets over 500 cubes of big block chev in it all sins will be forgiven!
Should we change the wheels? Haha

Engine mocked up in XB falcon sedan so we can fill up all unnecessary holes and smooth out engine bay
29/06/2017

Engine mocked up in XB falcon sedan so we can fill up all unnecessary holes and smooth out engine bay

Mazda MPS we rolled the rear guards on last week, turned out great and no paint damaged!
29/06/2017

Mazda MPS we rolled the rear guards on last week, turned out great and no paint damaged!

23/06/2017

Finally got clutch throw out bearing from the states. All plumbed up and out for the first test run. Apart from a small exhaust leak and one blown bulb everything went well. Not far from being thrashed on the street!

Dynamat almost all done on the 38 chev sedan. Getting close to being finished now.
13/06/2017

Dynamat almost all done on the 38 chev sedan.
Getting close to being finished now.

08/06/2017

Nathan's crate motor first start up. Fired up straight away and ran nice.

Fuel injection setup I am doing for the 454, eventually should also have 2 rather large turbos joining it too!
02/06/2017

Fuel injection setup I am doing for the 454, eventually should also have 2 rather large turbos joining it too!

A 454 big block chev I'm working on, new forged pistons, double row timing chain, big mu**er thumber camshaft and large ...
02/06/2017

A 454 big block chev I'm working on, new forged pistons, double row timing chain, big mu**er thumber camshaft and large rectangle port heads.
Should hopefully wake up the car it's in!

Address

Invercargill
9810

Telephone

+64274719812

Website

Alerts

Be the first to know and let us send you an email when XTC Rods and Restoration posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category