Gunttuning

Gunttuning Tuning specialist Engine builder and mechanical workshop

Don’t forget to be booked in before you can travel more than 5 miles , have your maintenance up to date and be ready to ...
05/06/2020

Don’t forget to be booked in before you can travel more than 5 miles , have your maintenance up to date and be ready to open it up

We had some guys in , where they paid for uprated fuel pumps to be fitted , but the Installer decided the hot wire proc...
13/03/2020

We had some guys in , where they paid for uprated fuel pumps to be fitted , but the Installer decided the hot wire process made them to noisy so he doesn’t do it any more , hot wiring ( supplying alternator voltage through adequate cable to support the amps the motorsport pump requires ) even a standard pump can net a massive flow gain on a standard fresh pump , but if you don’t want the noise fit a Std supra pump and wire it according . It seams there’s so much new info on line that the guys with 40yr experience are lost in the crowd . The info is out there you have to go to the right places

27/08/2019

With the introduction of the allowance of up to 10% ethanol in petrol means its killing the older systems pre 00/02 cars , their tanks pumps lines are just not designed to take it. So make sure you add some protection as it’s far cheaper than full system replacement , not forgetting turbo engine being very prone to failure if there is fuelling issues , we’ll post a link to the recommended products .

Some Garrett GTX custom goodies from Owen Developmemts , capable of pushing 450bhp with less lag that the old 280bhp all...
28/08/2018

Some Garrett GTX custom goodies from Owen Developmemts , capable of pushing 450bhp with less lag that the old 280bhp all in the same foot print , it's a no brainier realy , for once there's no drawback / sacrifice

So after some time fighting Electrial gremlins , we finally get so data form our hybrid CT9 , it's designed around the 4...
08/05/2018

So after some time fighting Electrial gremlins , we finally get so data form our hybrid CT9 , it's designed around the 4e but it landed on this 5e as an upgrade for now . This is a bolt on with a decat at only 1.2 falling to 1 bar full Std , it's not far of Evo and Sti tq figures while still pulling 30 bhp more than a Wrx in the light weight glanza , more power to come as we wind it up , far better alternative to the tdo4 , and if your thinking that route we have a full manifold turbo downpipe kit that has nearly the same lag as our CT9 but a 450 bhp Top end

Sti running wiseco pistons, a new v7 rods and a set of AVCS heads all for a GC8 type-r . We had to strip nearly 3 engine...
14/02/2018

Sti running wiseco pistons, a new v7 rods and a set of AVCS heads all for a GC8 type-r . We had to strip nearly 3 engines to illuminate Wrx bits that had been cobbled together. It's faster and cheaper to jump up to the new engines than go through the mindfield of the older stuff , this took Std and tighter ACL bearings to achieve the required oil clearances along with good oil control from a ported 11mm oil pump and block to the Roger Clark sump baffle, should all go along way to the ej20 reliability

When it's time to eke up a 140bhp Tdi , a remap and custom billet turbos see's over 210 . Then u run into the sloppy VW ...
19/01/2018

When it's time to eke up a 140bhp Tdi , a remap and custom billet turbos see's over 210 . Then u run into the sloppy VW suspension with a set of bilstein updated shocks and Eibach springs should keep all under control finished off with 4 wheel geo

Seeing as everyone has to run 1.6 or lower to obtain the motorsport liesence we started with the cheapest engine to get ...
17/01/2018

Seeing as everyone has to run 1.6 or lower to obtain the motorsport liesence we started with the cheapest engine to get to 200 bhp , 4age 20v , as the come with itb's out of the box and for now it's out the door with exhaust a M4 and our custom crank and cam pickups where cams and Pistons later will take it up to the 200

So May options nowadays on what to fill this hole with for some rwd mk2 fun
25/08/2017

So May options nowadays on what to fill this hole with for some rwd mk2 fun

It's time I better finish up this , took me a while to get my head around the cam timing not use to working on tings wit...
25/07/2017

It's time I better finish up this , took me a while to get my head around the cam timing not use to working on tings with such a short stroke , valve springs were shot to hell only making half the service limit , then people wonder why it dropped a valve , far cheaper to catch in time

More deliveries in of finished parts , could we have built this engine a bit to extreme
21/07/2017

More deliveries in of finished parts , could we have built this engine a bit to extreme

Address

Rathconrath
Mullingar
EIRE

Website

Alerts

Be the first to know and let us send you an email when Gunttuning posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Gunttuning:

Shortcuts

Share