Sdg autos

Sdg autos Mobile mechanic of 30+ years. Covering the south east. Custom repairs,servicing,mot repairs,welding.

A customer called me saying his wife’s Ford had a rattle/vibration when she turned the a/c on and could I help. I went r...
03/06/2026

A customer called me saying his wife’s Ford had a rattle/vibration when she turned the a/c on and could I help. I went round and found the engine cooling fan motor had excessive play/wear in it and it was rattling about when it switched on.
A new cooling fan and controller fitted and it’s all nice and quiet again.

A customers Skoda rapid alternator belt shredded and he called me round to fix it.I found the engine oil cooler that’s a...
01/06/2026

A customers Skoda rapid alternator belt shredded and he called me round to fix it.
I found the engine oil cooler that’s above the alternator belt was leaking oil from a failed seal and it had been dripping onto the belt causing it to fail. I also found the free wheeling pulley on the alternator was seized so a new pulley, belt and oil seal fitted and it’s back on the road and charging at 13.90 volts.

A customers little Vw polo needed a full service, new front exhaust sleeve (old one corroded and loose) but the first jo...
01/06/2026

A customers little Vw polo needed a full service, new front exhaust sleeve (old one corroded and loose) but the first job was to replace the broken plastic bonnet release lever so i could open the bonnet.
As you can see by the gap in the spark plugs they were well overdue replacing. It’s all done service book stamped and back on the road.

A customer had a little argument with a wooden post in his Ford kuga and managed to damage the o/s/r door. The cheapest ...
22/05/2026

A customer had a little argument with a wooden post in his Ford kuga and managed to damage the o/s/r door. The cheapest and quickest way was to get a good quality second hand colour matched door. I went round today and replaced it for him as you can see in the pictures it matched up and fitted perfectly. Another happy sdg autos customer.

A customer called me asking if I could look at the air conditioning on her (new to her) little Vw polo as it wasn’t work...
20/05/2026

A customer called me asking if I could look at the air conditioning on her (new to her) little Vw polo as it wasn’t working.
I went round and found the metal pipes going to the condenser had snapped off (looks like it’s had a bit of a shunt) so a shiny new condenser fitted and it’s all booked in tomorrow at a local garage to have an a/c re-gas.

A customers little mk1 fiat cinquecento wouldn’t start and he called me round to have a look. I found there was no spark...
20/05/2026

A customers little mk1 fiat cinquecento wouldn’t start and he called me round to have a look. I found there was no spark after a couple of tests i traced the problem to a failed tdc sensor a new sensor ordered and fitted and it’s back up and running fine again.

Back to finish the welding on transit connect today I had to cut out and repair the n/s/r inner sill then onto replacing...
19/05/2026

Back to finish the welding on transit connect today I had to cut out and repair the n/s/r inner sill then onto replacing the corroded outer. It’s all done seam sealed and stone chipped and I will be back tomorrow to give it a sq**rt of cavity wax and put all the trims back on.

Back to finish the Nissan welding today I had to repair the o/s/f floor then onto repairing the o/s outer sill and n/s/r...
15/05/2026

Back to finish the Nissan welding today I had to repair the o/s/f floor then onto repairing the o/s outer sill and n/s/r outer sill. The car is also having some bodywork done so the bodyshop are going to stone chip and colour match both the outer sills and cavity wax all the back of all the new panels once the car has been painted.

I managed to dodge the rain today a local bodyshop called me in to weld up this old Nissan 200 SX. I started on the n/s/...
13/05/2026

I managed to dodge the rain today a local bodyshop called me in to weld up this old Nissan 200 SX. I started on the n/s/f chassis it’s all-ready had some welding done but unfortunately that’s corroded away as well. Some nice thick 2mm plates made up and welded on and the n/s/f is all done then on to the o/s/f I’ve made a start and will be back tomorrow to carry on with the rest of it.

A customer called me asking if I could replace the corroded outer sills on his Ford transit connect. I started on theo/s...
12/05/2026

A customer called me asking if I could replace the corroded outer sills on his Ford transit connect. I started on the
o/s today I had to first repair the rear inner sill then onto removing and replacing the outer sill. This side is all done seam sealed and stone chipped ready to be put back together tomorrow hopefuly🤞it doesn’t rain then onto replacing the n/s.

Address

Tonbridge

Opening Hours

Monday 9am - 5pm
Tuesday 9am - 5pm
Wednesday 9am - 5pm
Thursday 9am - 5pm
Friday 9am - 5pm
Saturday 9am - 5pm

Telephone

+447800587447

Website

Alerts

Be the first to know and let us send you an email when Sdg autos posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Sdg autos:

Shortcuts

Share

Category