07/09/2024
That was fairly ExZorsting 👀 grew up watching my old man build exhausts from a single length of tube and a pipe bender, from Rolls Royce, American imports lots of custom cars long before the likes of pattern parts were readily available. I’m far from what he is capable of as he’s now retired but watching his approach over them years and little tricks of the trade gave me the inspiration to take this on myself. 2ft clearance on axle stands so I had limitations. I planned it all out so purchased several mandrels in stainless304 and after lots of cuts and improvements I now have an almost complete exhaust system. It’s currently centre exit setup without a cutout or tip but in 2 minds of whether to use the existing offside exit. Mig welding is getting better but by no means perfect, I invited the old man over for an inspection and given the setup he gave me the nod which was good enough for me. I will later revisit and improve, equally I’ve left enough room for a centre box if it’s too loud with just a rear silencer. Everyday is a lesson 🙏🏼