Baynton Jones

12/08/2026

I think that triggers the Beer protocol.

20/06/2026

Congratulations Steve McEvoy, winner at last !

17/06/2026

17/06/2026

Story of an Alternator installation using the Supercharger drive cap as a pulley! Lovely single wire, self-exciting Alternator by WOSP makes the installation super easy to connect on a car that was originally built for racing with no road equipment and minimal electrical circuitry way back in 1996. Now road equipped and electrical power to spare.

17/06/2026

MG crank oil slingers machined and this time we used a push broach to cut the keys. This setup uses a hydraulic press to push the cutter through the job. .......more of a Nut Cracker to crack a nut in this case !
IYKYK.

Simple seal conversion we have used for over 40 years uses an INA lip seal to replace the original return scroll.

17/06/2026

Update on Q/R steering, the column length is now checked, finalised and the splined shaft has been pressed on, cross pinned and welded in place. Ready for final assembly.

11/06/2026

"Sledgehammer to crack a nut"?
No, Slotting machine to cut a Keyway😀
5mm wide key being cut in a very tough blower drive coupling. One of those days when having the right machine for the job is the only solution!

29/05/2026

Huge fun at Prescott last weekend, and a rare photo opportunity under the hallowed sign with my car.

Thanks to all involved, especially the Orange army for long hot days, and for sweeping up after me!.....no digger required this year at least🤣

21/05/2026

Quick release steering for the J4 rep, where no doors means that even the slimmest of drivers can use some extra room to manoeuvre!

21/05/2026

Freshly poured main bearings. That is proper DIY.
Dad taught me how to do this when I was still at school, now over 40 years ago🫣