28/04/2026
Caddy CR140 transformation 😎
If you own a CR140, stage 1 tune not enough and looking for ultimate bang for buck set up this is it!
JW Automotive CR170 hybrid turbo, 4 bar map sensor, exhaust system and front mount intercooler.
We flashed stock file on with relative software deletes and map sensor scaled in to get out of limp mode and get a full run to monitor everything. Boost control was perfect even on stock software mirroring request all the way through the rev range. This makes our life much easier when tuning and credit to the turbo builder, so many poor hybrid turbos on the market set up completely wrong but this was bang on.
We spent most the morning tuning this on the Dyno, loads of revisions to find the sweet spot of making good repeatable power and keeping the temperatures within limits.
Finished up with a peak of 2bar tapering down to 1.6bar of boost hitting almost 250bhp. Peak numbers only tell half the story on this set up, hitting 200bhp below 3k revs and holding the power to almost 5k that’s what makes for a fast vehicle on the roads, epic area under the curve on this!
Stock - 146bhp / 326nm
HTS Tuned - 248bhp / 491nm
Proven gains of 102bhp & 165nm
________________________________
If you are sending enquiries through the website then please remember to check spam/junk mail folder for replies. We are experiencing issues with email replies at the minute. Alternatively you can contact us through messenger or WhatsApp with the contact number below.
________________________________
📞: 01463 213622
📧: [email protected]
📲: 07957615309
👩💻: www.higgstuningservices.co.uk
📍Lotland St, Inverness, IV1 1ST