Gubsport

Gubsport Sharing a passion for Motorsport with driver Joe Gubb for everyone to enjoy. A community packed with Retrocars and a variety of Motorsport.

Sharing a passion, keeping it real and having a laugh with a great bunch of friends plus motorsport pics and news for fun ๏ฟฝ

23/08/2026

22/08/2026

Made some head light blanks.

Stickers from I Say Ding D**g Ltd.





RS COMBE
RetroStock.ie

28/07/2026

GAZ Shocks
Do you run a short/tarmac front Gaz Gold strut for a mk2? If so can you post a picture of your droop. I will start in the comments ๐Ÿ‘๐Ÿฝtell me your thoughts?

One more bit done๐Ÿ‘Š๐Ÿฝ
28/06/2026

One more bit done๐Ÿ‘Š๐Ÿฝ

Underside done. Bit more prep and the boot and engine bay will be done ๐Ÿ‘Š๐Ÿฝ         nderside done. Bit more prep and the b...
28/06/2026

Underside done. Bit more prep and the boot and engine bay will be done ๐Ÿ‘Š๐Ÿฝ

nderside done. Bit more prep and the boot and engine bay will be done ๐Ÿ‘Š๐Ÿฝ

Inspired by the 90s Repsol Cosworth.Thoughts?
22/05/2026

Inspired by the 90s Repsol Cosworth.

Thoughts?

06/04/2026

The importance of spectators!

They can often build dreams, evolve into a career for some but more importantly make memories for the next generation ๐Ÿ‘๐Ÿฝ

Swaps. I have a set off Gaz gold 13inch short looking to swap for a new set of 14inch body long shocks new or might cons...
25/03/2026

Swaps. I have a set off Gaz gold 13inch short looking to swap for a new set of 14inch body long shocks new or might consider a good set of Bilstein Tarmac spec or even sell them but as they have only been test fitted they won't be much below retail. I have various lengh and poundage springs I will chuck in. Anyone interested? ยฃ1100 ono delivered

The splash shield on both sides had previously been welded prior to my ownership 35mm in tighter than it should be. Idea...
09/03/2026

The splash shield on both sides had previously been welded prior to my ownership 35mm in tighter than it should be.

Ideally I should of removed and replace the panel in the correct location, then connect the cage in the more traditional way by drilling into top the tub face.

Because of it's location this wasn't possible and as the panel is in good order with no rush I cut into the panel, and here we are.

I still have to cut a hole out to access the lower part of the cage joint so Baz can weld it.

More updates to come but what's your thoughts ?

Cheers

Address

Castle Combe, Chippenham, Wiltshire SN14 7EY
Chippenham
SN14 7EY

Alerts

Be the first to know and let us send you an email when Gubsport posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share