Wall-Fab

Call Directions Website

Wall-Fab Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from Wall-Fab, Automotive, aircraft & boat, Springvale, Wagga Wagga.

With 30 years of experience in the preparation and racing of rally and circuit racing vehicles, Wall-Fab can assist you with your motorsport vehicle preparation.

16/11/2026
16/11/2026
15/11/2026

James O'Malley and James Ford are right in the fight at Oberon, sitting 6th outright and still charging through the afternoon stages 👌💨

The Toyota 86 is looking right at home on these old-school forest roads. One more loop to go, so no lifting now.

15/11/2026

Dust flying and absolutely no room to breathe for James O’Malley and James Ford at the Southwest Excavations Rally of Oberon 👀💨

The Toyota 86 crew is right in the thick of it, with just three seconds in the fight for second in the two wheel drive component heading into the final loop of stages. That is proper old-school forest rally pressure.

With Oberon’s roadbook-only format and Jenolan Forest roads serving up the sting, this one could go either way. Who’s keeping it tidy and who’s sending it? 😅

12/11/2026

James O’Malley will head to this weekend’s 2026 Southwest Excavations Rally of Oberon with his sight firmly set on finishing the season as NSW 2WD Rally Champions. Full story in the comments!

Another complete Datsun rear disc brake kit going out the door. Everything you need, vented discs, new callipers, callip...
27/09/2026

Another complete Datsun rear disc brake kit going out the door. Everything you need, vented discs, new callipers, calliper hardware, calliper mounting brackets, competition pads, high tensile fasteners and braided brake lines.

Good to see our new design is holding up to the punishment and doing its job.
23/09/2026

Good to see our new design is holding up to the punishment and doing its job.

Front strut service week for the Toyota 86 of the O’Malley Rally Team after a wet rally at Ada River Rally

Datsun cold air intake system.After a fair bit of R&D work I have finally completed my first cold air intake system for,...
16/09/2026

Datsun cold air intake system.

After a fair bit of R&D work I have finally completed my first cold air intake system for, in this case an L4 Datsun motor with twin 45mm Webers in an early Datsun Stanza. The kit allows for cold air to be drawn in from the openings in the radiator support panel. Rather than sucking in hot air from the radiator and off the extractors. In this case I was able to make it use existing openings behind the inner headlight. Other models may require additonal holes to be cut in the radiator support panel.

The kit includes:
*A custom fabricated air box with 102mm inlet and removable lid. All 1.5mm aluminium.
*A 1.5mm aluminium extractor heat shield.
*Zircoflex heat reflective film to cover the base of the air box and the heat shield. Zircoflex claims a heat reduction of up to 85% with this film.
*A custom designed and 3D printed air collecter for the fire wall. This is printed in tough heat resitant ABS plastic.
* 102mm silicon air ducting.
* Mesh screen.

Please note, this particular heat shield has been bent and shaped to suit Stewart Wilkins extractors and a copy of the Datrally style inlet manifold.

Hopefully the car owner will send it back to the engine builder at some stage soon to see what performance increase has / can been made.

Address

Springvale
Wagga Wagga, NSW
2650

Alerts

Be the first to know and let us send you an email when Wall-Fab posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Share