Wyong Automatic Transmission Service

26/12/2024

28/04/2024

Looking for and upgrade to you Holden Colorado with bad lockup shudder? This is the perfect Torque Converter upgrade.

The Converter cover is made from a one piece steel billet (no welding of rings to the old pressed steel cover).

Thicker one piece ring area on the front cover where bolts go to reinforce the front cover, this helps to reduce flexing during converter clutch application.

New Thicker billet lockup piston made to replace the original pressed steel one,

Fully machined on our own CNC Lathes, Australian Made.

When fitted with a valve body upgrade and replacement of the pump pressure regulator valve it is the perfect upgrade combination.

Call, Messge or email us about your upgrade today.

22/12/2022

Merry Christmas and Happy New Year to all our customers! Thank you again for another great year.

Christmas/ New year trading hours are-

Closed from 12pm on the 23rd of December and re open on Tuesday the 3rd on January.

🎄🎄🎄🎄🎄🎄🎄🎄🎄🎄🎄🎄🎄🎄🎄🎄

22/12/2022

Go over and give Jet Racing a follow hope they like there 4L80E ‘

30/01/2022

Rest In Peace.

26/01/2022

Locker spider shaft pin trying to escape on this diff centre

26/01/2022

Making a new loader Transmission Torque Converter throat.

07/12/2021

Wyong Automatics is excited to announce the release of the Ford Ranger/ Mazda BT50 Series 2 billet torque converter cover. These covers are the ultimate upgrade.
Design improvements we have made on the factory cover are -
The back ring has been removed (a known failure point to break off) and the cover has been made thicker for better lockup apply, and to assist in reducing cover flexing. Bolts have then been used to secure the converter to engine flex plate.
Inside, a hub and cap have been fitted and bolted in for ease of servicing. In addition the rivets have been removed from the back of the converter to eliminate a known leak point.
New drive springs are fitted to every unit (another known failure point).
These Ford Ranger/ Mazda BT50 Series 2 billet torque converter covers are sold on an exchange basis.
This design has been registered under #202114741

21/11/2021

Ford 6R80 Hard line adaptor fitting, You can remove the heat exchanger and fit these in place, so you can fit your own oil cooler.
These fittings were designed and machined by us.
We sell these in pairs message or call us for more info.

12/10/2021

Custom bolt together converter being made for a Holinger Transmission

21/04/2021

Bolt together Converters we have been working on recently these will be using a GM core’s,
These will be made to make quick stall adjustments.

02/02/2021

Was great to help out MadMatt on this one.
With a better performing A442F Transmission
For his 80 Series build for his upcoming event at Cliffhanger.