Hy-Tone Motor Trimming

Hy-Tone Motor Trimming We specialise in all types of interiors, including boats, trucks, buses, planes, stretch limos, trac please refer to Facebook’s guidance on this.

***************************************************************
Our Commenting Policy:
All conversations and posts should be constructive, respectful, and contain language that is appropriate for all groups and ages. We therefore reserve the right to disallow comments that:

- are obscene, indecent, profane, or vulgar
- contain threats or personal attacks of any kind
- contain offensive terms dire

cted to ethnic or racial groups
- are defamatory, libelous or contain ad hominem attacks
- promote or endorse a product or service
- are excessively repetitive or constitute SPAM. Comments that do not adhere to the above guidelines will, without exception, be removed. In cases of repeat offenses, we will take action to block offenders from the page. Please note: Our moderators do their best to ensure this policy is adhered to fairly and consistently. If you would like to report abuse, spam, fake profiles, etc. Also know that you can always report any individual comment as “abuse” or “spam” by scrolling over the comment and clicking on the “x” in the upper right corner.

Last one for the year! This beautifully presented Cobra with its deep blue body and tan interior just works so well toge...
22/12/2023

Last one for the year! This beautifully presented Cobra with its deep blue body and tan interior just works so well together. There was a lot of custom fabrication in this car from the removable fibreglass sill inserts, aluminium hinge covers, aluminium rear wall cover, steel fabricated console the list goes on. We covered everything in this car in Hans Reinke leather from Germany.

This HR ute was a real survivor, brought back to life and restored in its original glory. We matched the original interi...
22/12/2023

This HR ute was a real survivor, brought back to life and restored in its original glory. We matched the original interior colour and design perfectly, along with the doortrims and parcel tray.
We installed a new retro-radio along with a new 4X6 speaker in the dash which actually sounds really good. We used original style tonneau material for the tub and installed the correct number and style of fasteners to keep with the original style.

The RFS needed some quick release covers made up to protect the hoses on the side of this water tanker. We found these A...
30/11/2023

The RFS needed some quick release covers made up to protect the hoses on the side of this water tanker. We found these Australian made quick release buckles and solid mounted them to the side of the trailer using stainless fasteners, then used heavy duty webbing to secure the cover and tie down the hoses to stop them moving around. The cover can be lifted up and secured down in a matter of seconds.

Looking for a premium leather cleaner and a moisturiser? Want to prolong the life of your leather in your car or lounge ...
25/10/2023

Looking for a premium leather cleaner and a moisturiser? Want to prolong the life of your leather in your car or lounge at home? This leather cleaner and moisturiser doesn’t leave a smell behind and has no nasty chemicals. You can purchase them along with many other Evalence car care products on our new revamped website www.hy-tone.com.au

For this tinny we replaced the floor with new A-bond structural ply wood and layered on some Gelcoat to protect it again...
01/09/2023

For this tinny we replaced the floor with new A-bond structural ply wood and layered on some Gelcoat to protect it against the water. We also installed some SeaDeck on the seating area to take the heat out.

We changed this VF SS interior using new foam pads from the GTS and redesigned the rear seats to match. We also swapped ...
10/08/2023

We changed this VF SS interior using new foam pads from the GTS and redesigned the rear seats to match. We also swapped out the original steering wheel for a GTS unit and added red stitching to some custom floor mats

This forklift needed some clears covers made but we couldn’t drill into the “roll bar”. So we made up some Aluminium bra...
07/08/2023

This forklift needed some clears covers made but we couldn’t drill into the “roll bar”. So we made up some Aluminium brackets and had them powdercoated to match the roll bar colour, then fitted the fasteners to the brackets. We then went onsite and hand fitted up a pattern, went back to the shop and made up the covers. Then back down onsite and used Sikeflex to glue the fasteners to the roll bar then fitted the covers. Quite a lot of work for some clears but it was worth it in the end.

This Commer truck came in as a bare shell, no insulation, hot and very noisy. We first sanded the rust from the interior...
07/08/2023

This Commer truck came in as a bare shell, no insulation, hot and very noisy. We first sanded the rust from the interior surface and applied a layer of Dynamat. Then added foam to the turret and rear wall to give a smooth surface to glue the green Tweed cloth to. We also custom made a metal cover for the wiper motors and hand made door surrounds.

The seat was custom covered in a mix of green distressed vinyl and green tweed. Hand fitted and slightly bolstered as there’s not a lot of room in the cab of this truck, we tried to get the seat down as much as possible without compromising on the comfort.

The carpet was hand fitted to the floor, firewall and front 1/4s, along with a removable floor mat that surrounds the custom console which was made to slide up under the dash and be easily removable by taking out some custom stainless bolts.

The doortrim backing boards were made from Alupanel and hand fitted as to be as thin as possible and still look great in the car. We also covered the door lock springs in felt and removed all the rattles from the door cavity.

This 1966 Lincoln coupe came in for a bit of a tidy up we replaced the torn leather on the rear seat and recovered the ...
02/07/2023

This 1966 Lincoln coupe came in for a bit of a tidy up we replaced the torn leather on the rear seat and recovered the armrest and rear panels on the front seat. Fixed up the doortrim panels and gave the seat runners a good grease.

A dash we covered for a Land Rover Defender, we added some custom vents, filled in the ash tray on the upper dash panel....
29/06/2023

A dash we covered for a Land Rover Defender, we added some custom vents, filled in the ash tray on the upper dash panel. One of the pieces had some rust and was missing the attachment section, we made up a new piece and welded them together, then sent them off to be sandblasted and powdercoated. Can’t wait to see how they look in the car!

This bus is the newest edition of the Sydney Party Limos fleet. We hand fitted the highest quality materials to custom m...
28/06/2023

This bus is the newest edition of the Sydney Party Limos fleet. We hand fitted the highest quality materials to custom made foam pads to give the bus an over the top and crazy interior when all the RGB LEDs lights come on.

Address

42 Wellington Street
Riverstone, NSW
2765

Opening Hours

Monday 7:30am - 5pm
Tuesday 7:30am - 5pm
Wednesday 7:30am - 5pm
Thursday 7:30am - 5pm
Friday 7:30am - 5pm

Telephone

+61296272086

Website

Alerts

Be the first to know and let us send you an email when Hy-Tone Motor Trimming posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Hy-Tone Motor Trimming:

Shortcuts

Share

Category