RETRO SPARK Auto Electrical

26/08/2025

Evening all.
Time for an update.
Just finished a great job for a new mate, Jack.
Jack's car was started a long time ago however, wasn't able to be finished.
It's always a challenge to finish off what someone else has started but it was started properly so that made things a lot easier.
In the end, it was great to get the job done and awesome to see Jack renew his passion for his truck.
Enjoy the photos, Cheers.

28/10/2024

Morning all, it's been a minute!
Getting through a house build and relocating to country Vic has kept me busy.
Stand by for some updates, another Camaro build with the lot and even some updates on my personal build.

Cheers.

02/05/2021

Hey guys, well it took a bit but the results speak for themselves. Complete re-wire using a Painless 28 circuit kit, Dakota Digital dash kit and a bit of Retro Spark trickery. Looks better than factory which was the customers request. Final fit and finish will happen after paint.

29/03/2021

Hi guys, been a while since I posted but we're back. Currently doing a full painless kit into this 70 Camaro. Today I wired in a new set of LED lights for the indicators and reverse lights. These new lights give your car the look of a modern car with alternating white and amber colors. They're perfect for a duel circuit Parker/indicator setup on the front as well. Check out the vid. Cheers.

27/10/2020

Well, here it is, the not so secret COVID project. Reedy's HJ ute. LS1 conversation with E85 carb conversation. We installed a new MSD system to get it up and running, new wiring setup for the engine bay, dash wiring loom, removed 13 unused relays and installed a new stereo system. Along the way, we also moved the battery to under the tray, installed rear headlight covers to hide the thermo relays and mounted the trans cooler under the tray. She now looks, sounds and runs sweet. Cheers Reedy, can't wait for rego and some 'test' driving, enjoy.

26/10/2020

We're back guys and gals. Currently working on an AP5, wiring cleanup, some new paint in the engine bay, install heater and some fault rectification. It's great to get back into gear, stay tuned for more pics of the secret COVID project we just finished. Cheers Aaron.

26/10/2020

24/06/2020

Hey guys and gals, finally got to Richo's and started up the beast. You might remember we built and installed a full custom wiring and power management system for the XW. We'll, enjoy what all the hard work sounds like. Spoiler.... AWESOME!

13/05/2020

Fully wired and ready for wrapping up. Had to mount the MSD upside down to allow access to the rev limiter switches.

05/05/2020

Putting together the power management and engine module board. This will be located out of the engine bay to keep it looking clean and uncluttered. Will also ensure power requirements are met and all systems are electrically protected.

02/05/2020

Check out our new logo! Comment below your thoughts.

a) Trendy
b) Amazing
c) It's alright
d) Other

20/04/2020

Completed works
Sam's Pride and Joy
Land Rover
1975
Short Wheel based