Border Rivers Cylinder Heads

24/08/2026

After a few calls lately, we've managed to source some B/2B/Early 3B cylinder heads.
If you were one of those callers, feel free to ask the question again!

Send a message to learn more

20/08/2026

And here we go for a comprehensive thread repair.
We set the cylinder head flat on the Rottler bed once the holes were clean, we then drilled and tapped a 14mm thread into it. We installed a bolt with plentiful retaining compound, cut and snapped it off similar to an oversized A plugin a crack repair, surfaced it flat, then traced the original centres and drilled and tapped it back to 8x1.25 thread.
All that times three.

19/08/2026

In today’s episode of “How Bad Can Someone Screw Up?” we have this little beauty.
A reconditioned head came in for us to check out. This was one of the many issues. The shiny spot at the top of the drilled hole is the centre of the old broken bolt. The lower one was where I managed to remove the last of the broken bolt extractor.
They just left the mess hoping that the purchaser of the head wouldn’t notice.

29/06/2026

We are still on the look out for a new home with 3 Phase power and enough room to swing a crank or two.
Call us if you know of anywhere!

23/06/2026

22/06/2026

Setting up a crankshaft for a 100 year old oil burner.

03/06/2026

We are looking for a new home for Border Rivers Cylinder Heads.
We are looking for a shed with 3 phase power and enough room to house our expanding machine list, ideally before EOFY.
If you believe you have or know of an opportunity reach out to us.

Send a message to learn more

17/04/2026

Stand by for a big announcement in the coming days.

15/04/2026

We have been having issues with phone and internet over the last week or so. Please be patient as we’ve just diverted the phone to Stan’s mobile.

06/04/2026

We will be closed this short week to give the guys a well earned break.
Sorry for the inconvenience.