PRO Touring fabrication

PRO Touring fabrication Specialists in fabrication
Chasis building
Hand crafting custom panels
Rust replacement panels
C
(1)

Torana hatch going deep ✅ rear floor/ tubs / extensions in. We have some tricky sill exit exhaust work to do before runn...
05/06/2025

Torana hatch going deep ✅ rear floor/ tubs / extensions in. We have some tricky sill exit exhaust work to do before running the sheet down through to the crossmember

C63s conversion using up every square inch of this c300 😍
29/03/2024

C63s conversion using up every square inch of this c300 😍

Factory style Rx7 gearbox tunnel mods to fit new driveline come up clean. Butt welded and lapped at firewall seam ...
14/03/2024

Factory style Rx7 gearbox tunnel mods to fit new driveline come up clean. Butt welded and lapped at firewall seam

Engine bay panels for the hardtop going down . Including a removable cover for the control arm pocket to allow easy adju...
02/02/2024

Engine bay panels for the hardtop going down . Including a removable cover for the control arm pocket to allow easy adjustment and some super deep details are the choice for this one . Simple + clean always works..

Sedan✅ coupe✅. A couple of classics in for some metalwork.
31/10/2023

Sedan✅ coupe✅. A couple of classics in for some metalwork.

🇦🇺 💪.
24/10/2023

🇦🇺 💪.

07/10/2023

Xb build has pretty much had the rear half of the car replaced, it’s no wonder you see so many of these for sale sandblasted 🤦‍♂️, The power hammer delivering the goods on the panels , quarter panel tuned up to the sweeps and looking great, inners and frame work in epoxy ready to fit next week . I cannot wait to have this buttoned up, I’ve had Alex busy machining parts to mount the driveline so we can move onto engine bay fab next 💪

Mercedes 300ce build with a full 2018 c63s driveline conversion front and rear 💪💪We were supplied with a full c63 shell ...
12/09/2023

Mercedes 300ce build with a full 2018 c63s driveline conversion front and rear 💪💪

We were supplied with a full c63 shell so we could cross reference and bring all the geometry into cad. We then modelled the chassis rails, ride height and wheel location of the receiving car and layered the c63 component locations over the top aligning the wheel centre line and the centre line of the car , we could then build out our plate work , strut towers, upper control arm mounts and subframe standoffs keeping all locations castor / anti dive and geometry.

The plate work is now in and fitting like a dream, from here we will strip it to finish all welding and cap off all the places we couldn’t get too with the driveline in , updates to come on this weapon .

Bit of sunlight moving the big girl around to carry on with the front end fab 👌 can’t argue with the shape of these 😍😍 ...
23/08/2023

Bit of sunlight moving the big girl around to carry on with the front end fab 👌 can’t argue with the shape of these 😍😍

Address

Brisbane City, QLD

Opening Hours

Monday 8am - 4pm
Tuesday 8am - 4pm
Wednesday 8am - 4pm
Thursday 8am - 4pm
Friday 8am - 4pm

Telephone

+61414413338

Website

Alerts

Be the first to know and let us send you an email when PRO Touring fabrication posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category