Cochino's Customs

07/22/2026

07/21/2026

Love to see riders out enjoying the builds that we do, big or small! 💪

Cochino's Customs

07/19/2026

*** Lids Lids Lids ***

Just a little info about how to approach a rear speaker upgrade!

Cochino's Customs

07/19/2026

Knocked this Road Glide out before I step out of the shop for a few days!

Four speaker setup! 🔊
This has a the Nemesis audio NEO- CX69CF in the lids.
Had to cut the RF stage kit 5x7s out of the lids and use an adapter kit to add the 6x9s.
We ran Diamond audio 6.5" up front and a ION 1600.4 amp mounted under the head unit and a Diamond Audio T harness!
A bit of a challenge because we had to remove all of the Rockford wiring to fit all of our wiring on the bike!

If you dont have lid speakers now, dont buy lids! Have them cut in! Especially if you have a beautiful color like this bike! They just fit better in the saddle bag! 🔊🔊🔊

Cochino's Customs

Disclaimer: No copyright infringement intended. The music belongs to its rightful owner."
"I hereby declare that I don't own the rights to this music/song. All rights belong to the owner

07/13/2026

Sorry I'm amped up on Monsters! Giving wrong info with my mouth... correction* lights are 5v, *cement resistors, *stereo thinks there is a blown speaker or impedance issue..

I crack the code that may or may not be cracked already! 🤣
Spyders with sea to sky headunits that you are using hi input (post factory amp speaker wires) to a dsp. This is my setup
Front left and right speaker wires ( + & -)(x2)
> cement resistors (10w 5% 47 ohm) >
Line out converter > ground loop isolator > digital sound processor > aftermarket amp(s)

You want to take one end of cement resistor to positive of left and the other end of negative of left. Repeat on right speaker positive to negative. Do this toward your dsp.

Amp remote wire is tapped in to alternator fuse on left fuse box if you are sitting on the bike. The left box is keyed, the right is on all of the time. I will put a Pic in comments.
A few Google answers will tell you to tap the right marker light and that will trigger an amp at 5v but on this bike I'm using a Sequencer and it requires 10- 14 volts (I believe) to trigger dsp, amp 1, and amp 2.

Hope this helps DIY or someone that is running in to these issues on Spyder RT install. 💪

Cochino's Customs

07/07/2026

💡🚨💡

Cochino's Customs