Griffin's Customs

09/10/2023

Finally cooling down enough I can get back in the garage. Got the cab cut and pushed out to the door (used to have a gap of almost 3/4 of an inch at the top). Also got a piece tacked in to start to close in the lower part of the cab.

07/16/2023

Made it out to a show this weekend. Humidity sucked but everything else was great!

07/07/2023

Making progress again. Steps are on (and she is nice a low) and patching the cab has begun!

06/25/2023

Doing a little summertime garage cleaning.

05/08/2023

My goal when I started the tear down/ swap/crew cab build in December was to make it to the for the 2023 car show. Made it and had a room with a view from the bed.

05/05/2023

VIP seating installed for the car show at the tomorrow. Hoping the rain holds off, I have too much bare metal to get rained on right now. If you are local and at the festival stop by and say hello! #1956

04/26/2023

Doing some brute force support of the front. This needs to keep me off of the fenders in the near term since I can’t figure out bump stops with the air bags. Also will become mounting for the bumper. Will add bars across as well as gussets back if I can figure out a way.

04/19/2023

Made another trip around the neighborhood this evening. This thing drives shockingly well. parts service might suck at anything helpful but damn if a isn’t a great runner even after sitting for 5 years. #1956

04/11/2023

03/13/2023

Working on installing kit on the . Closed the gap to the fender support from about 6 inches to less than an inch. Nice even if I do say so myself.

03/04/2023

Test fit of on the chassis with the complete. celebration commencing.

02/27/2023

Loads of progress on the . Got the installed and running. Cut the back off the main cab. Built the top halo to tie the cabs together. Finally test fit some rear doors. Lots of work and tweaking to do yet but making good progress finally!