Brutal Motor Works

Brutal Motor Works We specialize in LS/LT swaps on all GM vehicles. We also do swaps on BMWs and various other makes. located in Bellville TX 77418.

We only do one swap at a time so each vehicle gets our undivided attention.

Sometimes the problem is obvious and sometimes it's not. PSA: don't mount your PCM with the connector facing up and don'...
07/22/2026

Sometimes the problem is obvious and sometimes it's not. PSA: don't mount your PCM with the connector facing up and don't use Scotch locks!

07/22/2026

1985 c10 I recently completed, this is such a gorgeous truck!

07/22/2026

1969 Chevelle SS 396 I recently completed! I'd say my best work yet!

A swap I did for a customer is available. The customer is asking 25k. It's an 1989 k1500 short bed. 5.3/4l60e 4wd everyt...
01/17/2026

A swap I did for a customer is available. The customer is asking 25k. It's an 1989 k1500 short bed. 5.3/4l60e 4wd everything works

1977 C10 done! Just need to clean up the engine bay a bit more to make it look tidy.
07/17/2025

1977 C10 done! Just need to clean up the engine bay a bit more to make it look tidy.

Please refer to this for 98-2000 OBS LS swaps using factory OBS harness and aftermarket or stock LS GEN 3 DBC harness. -...
07/04/2025

Please refer to this for 98-2000 OBS LS swaps using factory OBS harness and aftermarket or stock LS GEN 3 DBC harness. -NOT HOLLEY- This mostly covers the fuel gauge and using the LS PCM for OBS factory AC wiring. Please note you should keep all OBS harness grounds and relevant sensor plugs like coolant temp and oil pressure, this is not for that. Simply move the pins from old PCM connector to new PCM connector as described no splicing or cutting wires. Please let me know if anything is incorrect and I'll fix it. THIS IS NOT FOR DRIVE BY WIRE BLUE AND GREEN PCM. RED AND BLUE DRIVE BY CABLE ONLY!!! There's very little clear information about this available online so I took the time to create a clear chart to make it simple.

Latest video just dropped and this one's pretty good!Go check it out!
06/12/2025

Latest video just dropped and this one's pretty good!
Go check it out!

1996 Tahoe 2dr 4x4KILLSHOT and Quickdraw, with hand made 0 gauge ofc battery cables!killshot EFI with:factory gauges and factory AC!America baby!notes:white ...

Installed the autometer digital dash in this Lt swapped square body today. Used the sta-1000 to acquire tachometer and s...
05/15/2025

Installed the autometer digital dash in this Lt swapped square body today. Used the sta-1000 to acquire tachometer and speedometer output from CAN off the OBD2 port, and fed that to the autometer. Had to do it that way because the 8l90 only puts out VSS over the CAN network, and most aftermarket clusters don't deal with proprietary CAN networks.

Just doing car stuff!
05/07/2025

Just doing car stuff!

Address

Bellville, TX
77418

Website

Alerts

Be the first to know and let us send you an email when Brutal Motor Works posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category