ウェブサイトとは何ですか？

Lembrosgame

Welcome to the official page of LemBrosGame! I'm deaf YouTuber, Gamer, and vlogger!!

24/02/2026

I almost touch Coin Coffer with a Star!

15/02/2026

The white pickup truck almost reverses into my FB6 *maybe not*

01/02/2026

The idiot semi-truck driver ran a red traffic light
Dashcam: N4 Pro S

26/01/2026

He is a cold start

08/01/2026

Welcome to the cold air intake by !!
That is my first time to install the cold air intake! It’s really easy to install, however it was hard because I was trying to remove the OEM air box due to a rubber grommet and hose for engine cover due to the hollow is too small for engine cover. I used a hot water and dish soap for hose, it was successful sliding to the engine cover.

Don’t use WD40 because rubbers will get corrosion or cracked. I suggest you to use a hot water and dish soap. And, the FB6 is now modified as a modification car and in the stage 1!😆

11/12/2025

The Ford Explorer ST passes and cuts me off at the construction

27/11/2025

Black turkey 🦃 Happy Thanksgiving Day!

26/11/2025

The Riolo Bros. of Japan cars

26/11/2025

7-Eleven with a carguy🌧️
Today, the paint restoration is successful. But, it is a little bit failure due to etchings, not smooth, and exposed few primer and raw metal due to excessive pressing sanding. Because it is a wrong time for November and fall time.

So, I will have to start over on the next May with tent or carport. November or winter time is not recommended because I can’t handle against the cold. May, spring time, or summer time is strongly recommended.

I also must remove headlights, rear headlights, fenders, molding corner, handlers, rear camera, both mirror sides, license lights, chrome trim, and both bumpers to can spray all of that body instead of tapes to tape over on it.

27/10/2025

Cars and Coffee at Gateway Shopping Center - 9/26/2025
It’s time for Halloween! Trunk or Treat!

23/10/2025

The paint restoration is in process. It’s a long time to go!

First, I sanded spot rust on my FB6 with 80-grit sandpaper until it disappeared. Then, I applied the body filler on dent metals and sanded it with 80 and 180-grit. Then, applied the glazing putty on the FB6 and sanded it with 320 and 400-grit. After I finished it, then I sanded the whole old paint and clear coat, and glazing putty with 320 and 400-grit. Then, I sprayed the primer paint on the FB6 to prevent it from corrosion. Then, I will paint with the base paint and clear coat next! And, I will polish it too!

I followed ‘s instructions!

21/09/2025

Cars and Coffee at SteelStacks - 9/21/2025 - Part Final

住所

Kyoto-shi, Kyoto
601-8501