John Hall Mobile ADAS Calibration

John Hall Mobile ADAS Calibration Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from John Hall Mobile ADAS Calibration, Automotive repair centre, Dalton.

I provide a mobile Advanced Driver Assist System (ADAS) calibration service for the motor trade using an accredited IMI technician (AOM230) following IIR and Thatcham guidelines and offer a full audit trail.

Very interesting pictures showing the before and after calibration views through the drivers parking cameras - This MG h...
20/08/2026

Very interesting pictures showing the before and after calibration views through the drivers parking cameras - This MG had only had a tailgate repair which involved removal and refitting of the rear camera ( No new parts ) and the difference is shocking - It really highlights the need to follow manufacturer methods all the time.

When that driver has an accident can you document evidence to say you did a correct and safe job - yes it’s only a tailgate but remember these body panels now play a part in a big safety system.

Just a couple of today’s jobs for a local Bodyshop - Kia EV shutdown in preparation for major repairs and a Toyota front...
07/08/2026

Just a couple of today’s jobs for a local Bodyshop - Kia EV shutdown in preparation for major repairs and a Toyota front radar and 360 camera calibration after bodywork repairs

Nice straightforward panoramic (360) camera system calibration and front radar calibration on a Citroen C5X
29/07/2026

Nice straightforward panoramic (360) camera system calibration and front radar calibration on a Citroen C5X

Interesting job for a trade friend today, no communication with front radar on a new Mazda after a nearside front impact...
20/07/2026

Interesting job for a trade friend today, no communication with front radar on a new Mazda after a nearside front impact, testing the communication network using genuine wiring diagrams proved a poor waveform which was linked to pulled wire in a connector not allowing the dedicated ADAS CAN network to operate with just one terminating resistor connected. Fault corrected, wheel alignment checked and a dynamic calibration carried out to confirm all operating correctly.

An interesting 360 calibration on a new Geely Starray requiring a large amount of indoor area to complete
08/07/2026

An interesting 360 calibration on a new Geely Starray requiring a large amount of indoor area to complete

Alfa Giulia, security gateway accessed correctly with manufacturers approved software followed by a wheel alignment pre-...
07/07/2026

Alfa Giulia, security gateway accessed correctly with manufacturers approved software followed by a wheel alignment pre-check and calibration of the front Haptical Lane Feedback camera for a local dealer using the awesome Autel IA600

A few VAG calibrations this week. Cupra Tavascan, Porsche Cayenne and Skoda Enyaq
03/07/2026

A few VAG calibrations this week. Cupra Tavascan, Porsche Cayenne and Skoda Enyaq

A forward thinking local BSI approved Bodyshop doing the job correctly calibrating camera and radar after chassis geomet...
26/06/2026

A forward thinking local BSI approved Bodyshop doing the job correctly calibrating camera and radar after chassis geometry adjustments following bodywork repairs to ensure the car is returned to the customer in ‘As new ‘ condition and documented safe.

Using the new Autel IA600 calibration tool which I am running alongside other tools for maximum coverage - impressed by ...
23/06/2026

Using the new Autel IA600 calibration tool which I am running alongside other tools for maximum coverage - impressed by the print out of measured angles to further prove accuracy.

Interesting job on a VW Amarok, both blind spot / lane change assist / rear cross traffic alert warnings showing after s...
17/06/2026

Interesting job on a VW Amarok, both blind spot / lane change assist / rear cross traffic alert warnings showing after setting off with fault codes in both side object detection control modules for ‘system obstructed’ after investigation both modules were found to be heavily contaminated with mud !

Address

Dalton
YO73HD

Opening Hours

Monday 8:30am - 5pm
Tuesday 8:30am - 5pm
Wednesday 8:30am - 5pm
Thursday 8:30am - 5pm
Friday 8:30am - 5pm

Telephone

+447871097909

Website

Alerts

Be the first to know and let us send you an email when John Hall Mobile ADAS Calibration posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to John Hall Mobile ADAS Calibration:

Shortcuts

Share

Category