SumoFab

SumoFab Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from SumoFab, Automotive, aircraft & boat, 2/36 Raws crescent Hume, Canberra.

Operating as usual

I have been waiting for this for a while now. The next step in what I can offer. If you need 3D scanning please contact.
02/03/2021

I have been waiting for this for a while now. The next step in what I can offer. If you need 3D scanning please contact.

I have been waiting for this for a while now. The next step in what I can offer. If you need 3D scanning please contact.

Very clean VK
21/07/2020

Very clean VK

Northmead Auto Centre
03/06/2020

Northmead Auto Centre

POR440 tuning all finished up, we ended up with 1044rwhp/779rwkw @ 33psi, going through all the fueling data we believe this stock/factory bottom end 5.3L L33 LS is showing 1200hp+/900kw+ at the crank. We can't wait till the track opens back up and Arby can get into the 8's. Current best time is [email protected].

5.3L L33
PowerGlide trans
9" diff
85mm Forced Inductions turbo
Haltech Elite 2500
United E85

My next job, hot side and cold side for this 69 Mustang.
16/02/2020

My next job, hot side and cold side for this 69 Mustang.

105 litre Vl tank underway.
18/01/2020

105 litre Vl tank underway.

Ls vegan 🌱 manifold fl**ge for mock up.
18/01/2020

Ls vegan 🌱 manifold fl**ge for mock up.

Who needs last minute welding repairs before Summernats? I’m here at work every day till New Year’s Eve. Aluminium/stain...
27/12/2019

Who needs last minute welding repairs before Summernats? I’m here at work every day till New Year’s Eve. Aluminium/stainless/mild.
Canberra.

Doing a little job for Integra Automotive. RB 25 in a Silvia. Very tidy little car.
26/11/2019

Doing a little job for Integra Automotive. RB 25 in a Silvia. Very tidy little car.

Got the tank temporarily mounted in the XE on Friday. It will eventually be about an 1" and a half higher and maybe the ...
24/11/2019

Got the tank temporarily mounted in the XE on Friday. It will eventually be about an 1" and a half higher and maybe the same amount further forward once the boot floor is redone.

So I was a bit like this hose today and burst under a bit of pressure and deleted the post it was in.
21/11/2019

So I was a bit like this hose today and burst under a bit of pressure and deleted the post it was in.

Some pics of Rob's XE headers when I was making them.
21/11/2019

Some pics of Rob's XE headers when I was making them.

Fuel tank for Rob's XE Falcon.Billet sides and 2 pieces of sheet. Only 4 welds to seal it up.  We added in some mount ho...
18/11/2019

Fuel tank for Rob's XE Falcon.
Billet sides and 2 pieces of sheet. Only 4 welds to seal it up. We added in some mount holes on the sides which can be used for whatever is needed. Fuel pump is the Automotive Phantom 800 hp brushless pump and module. Shiftkits Australia supplied the made to length fuel sender which is calibrated to suit the standard XE dash. Still needs the filler neck added.

15/11/2019

Rob Knights XE Falcon I have been working on. Exhaust is pretty well done other than rear drivers side mount as currently there is no rear chassis rail to mount it to . Real steel in Queanbeyan will be making a new drivers side chassis rail in place of the old spare wheel well as well as a flat floor in the boot area.
Pics in the comments.
Thanks Matt Hughes for your pics and vid.

18/10/2019

Awesome Lx Torrie at Autotech in Canberra. Motor is a 308/355 built by Sam and the gang at Westend Performance.

F1R small block.Setting up for injection with our trigger wheel. Should have the sensor mount finished next week.Engine ...
18/10/2019

F1R small block.
Setting up for injection with our trigger wheel. Should have the sensor mount finished next week.
Engine is going in a VK streeter.

Gas Gas dirt bike water neck.
10/10/2019

Gas Gas dirt bike water neck.

Some before and after pics of a ls head repair.
08/10/2019

Some before and after pics of a ls head repair.

New Cooler for POR440
08/10/2019

New Cooler for POR440

SumoFab's cover photo
08/10/2019

SumoFab's cover photo

SumoFab
08/10/2019

SumoFab

SumoFab's cover photo
08/10/2019

SumoFab's cover photo

If you think these type of parts would help on your next project please contact me. They make doing headers much easier ...
08/10/2019

If you think these type of parts would help on your next project please contact me. They make doing headers much easier and faster.

Pictures of the Twin 3" Mild Steel X-Piped system installed on the F100.
08/10/2019

Pictures of the Twin 3" Mild Steel X-Piped system installed on the F100.

Bill's Gap 'n' Slap 5.3.Ljms stage3 twin turbo camArp fasteners and ls9 gaskets.Std heads serviced.Should be interesting...
08/10/2019

Bill's Gap 'n' Slap 5.3.
Ljms stage3 twin turbo cam
Arp fasteners and ls9 gaskets.
Std heads serviced.
Should be interesting to see what it can do in Bill's Vl.

SumoFab's cover photo
08/10/2019

SumoFab's cover photo

SumoFab
08/10/2019

SumoFab

Address

2/36 Raws Crescent Hume
Canberra, ACT
2620

Telephone

+61468828758

Alerts

Be the first to know and let us send you an email when SumoFab posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Videos

Nearby autos & automotive services